The plasma potential at a typical substrate position is studied during the positive pulse of a bipolar high-power impulse magnetron sputtering (bipolar HiPIMS) discharge with a Cu target. The goal of the study is to identify suitable conditions for achieving ion acceleration independent on substrate grounding. We find that the time-evolution of the plasma potential during the positive pulse can be separated into several distinct phases, which are highly dependent on the discharge conditions. This includes exploring the influence of the working gas pressure (0.3–2 Pa), HiPIMS peak current (10–70 A corresponding to 0.5–3.5 A cm−2), HiPIMS pulse length (5–60 μs) and the amplitude of the positive voltage U+ applied during the positive pulse (0–150 V). At low enough pressure, high enough HiPIMS peak current and long enough HiPIMS pulse length, the plasma potential at a typical substrate position is seen to be close to 0 V for a certain time interval (denoted phase B) during the positive pulse. At the same time, spatial mapping of the plasma potential inside the magnetic trap region revealed an elevated value of the plasma potential during phase B. These two plasma potential characteristics are identified as suitable for achieving ion acceleration in the target region. Moreover, by investigating the target current and ion saturation current at the chamber walls, we describe a simple theory linking the value of the plasma potential profile to the ratio of the available target electron current and ion saturation current at the wall.
1 June 2023 in Plasma Sources Science and Technology
We investigate the electric field development in weak microseconds-lasting atmospheric pressure Townsend discharge operated in a barrier discharge arrangement in pure nitrogen. The electric field is determined using four different methods: laser-aided electric field induced second harmonics (EFISH), optical emission-based first negative/second positive systems (FNS/SPSs of molecular nitrogen) intensity ratio, electrical equivalent circuit approach and via determination of the Townsend first coefficient from the spatial optical emission profile. The resulting values of the electric field obtained by these respective methods, regardless of the differences in absolute values, lie within a reasonable range. The limitations and advantages of all methods are discussed in detail for the investigated discharge. The EFISH measurements are supported by re-computation of the effective interaction-path of the laser using an electrostatic model. The FNS/SPS method provides systematically higher values compared to other methods. We discuss in detail the potential origin of this discrepancy, as this method is at the limit of its applicability due to the low E/N values and we also consider the impossibility of full verification of the underlying assumptions. The focused discussion addresses best-practice issues and identifies possible future steps to improve each of the four methods under given conditions.
14 July 2017 in Plasma Sources Science and Technology
Two-photon absorption laser-induced fluorescence (TALIF) was utilized for measuring the concentration of atomic hydrogen in a volume dielectric barrier discharge (DBD) ignited in mixtures of Ar, H 2 and O 2 at atmospheric pressure. The method was calibrated by TALIF of krypton diluted in argon at atmospheric pressure, proving that three-body collisions had a negligible effect on quenching of excited krypton atoms. The diagnostic study was complemented with a 3D numerical model of the gas flow and a zero-dimensional model of the chemistry in order to better understand the reaction kinetics and identify the key pathways leading to the production and destruction of atomic hydrogen. It was determined that the density of atomic hydrogen in Ar–H 2 mixtures was in the order of 10 21 m −3 and decreased when oxygen was added into the gas mixture. Spatially resolved measurements and simulations revealed a sharply bordered region with low atomic hydrogen concentration when oxygen was added to the gas mixture. At substoichiometric oxygen/hydrogen ratios, this H-poor region is confined to an area close to the gas inlet and it is shown that the size of this region is not only influenced by the chemistry but also by the gas flow patterns. Experimentally, it was observed that a decrease in H 2 concentration in the feeding Ar–H 2 mixture led to an increase in H production in the DBD.
In an externally heated quartz atomizer, the most often used hydride atomizer for atomic absorption spectrometry, two-photon absorption laser-induced fluorescence (TALIF) was employed (i) to bring after four decades for the first time conclusive proof of the existence of H radical population sufficient to atomize hydrides thus confirming unambiguously the radical theory of hydride atomization and (ii) to determine the distribution of H radicals in the atomizer. Under typical operating conditions, H radicals are concentrated in an approximately 3 mm long cloud in the center of the optical arm and their peak concentration exceeds 1022 m−3, i.e. four orders of magnitude above the typical analytical concentration of hydride. The lowest detectable H radical concentration is in the order of 1019 m−3. The superb power of TALIF to determine the spatial distribution of H radicals in hydride atomizers for atomic absorption/fluorescence provides a route for elegant optimization of hydride atomization – just by establishing how the atomizer design and parameters influence the distribution of H radicals.
4 December 2017 in Plasma Sources Science and Technology
Coplanar dielectric barrier discharge (DBD) was ignited in pure water vapor at atmospheric pressure in order to generate highly oxidizing plasma with one specific type of reactive radicals. In order to prevent water condensation the used plasma reactor was heated to 120 C. The composition of the radical species in the discharge was studied by methods based on laser-induced fluorescence (LIF) and compared with analogous measurements realized in the same coplanar DBD ignited in air. Fast collisional processes and laser-surface interaction were taken into account during LIF data processing. It was found that coplanar DBD ignited in water vapor produces hydroxyl (OH) radicals with concentration in the order of 10 20 m −3 , which is higher than the value measured in discharge in humid air (40% relative humidity at 21 C). The concentration of atomic hydrogen radicals in the DBD ignited in water vapor was below the detection limit, which proves that the generation of oxidizing plasma with dominance of one specific type of reactive radicals was achieved. The temporal evolution, spatial distribution, power dependence and rotational temperature of the OH radicals was determined in the DBD ignited in both water vapor and air.
1 December 2019 in Plasma Sources Science and Technology
The evolution of N( 4 S) species produced by filamentary streamer discharge was investigated by two-photon absorption laser-induced fluorescence technique. A triggered single streamer filament was periodically produced in pure nitrogen at pressures of 20, 50, 100 and 200 Torr, and N( 4 S) species were monitored in the center of the discharge gap during the streamer formation, decay and afterglow. Under all of the investigated pressures, the population maxima of nitrogen atoms were observed in a microsecond timescale; i.e. well after the extinction of the streamer event. The concentration of nitrogen atoms increased with pressure. The maximum N( 4 S) concentration measured at 20 Torr was about 10 13 cm −3 , while it exceeded 10 15 cm −3 at 200 Torr. After reaching maxima, atomic densities exhibit hyperbolic decay, which was followed up to the post-discharge time of 0.5 ms. Our results show that only a small part of N( 4 S) is produced during the streamer transit or within 200 ns after the transit (20%–25% increase with respect to the background density), while most of the nitrogen N( 4 S) atoms are produced during the streamer channel decay in timescales from units to several tens of microseconds.