The high power impulse magnetron sputtering (HiPIMS) discharge is a recent addition to plasma based sputtering technology. In HiPIMS, high power is applied to the magnetron target in unipolar pulses at low duty cycle and low repetition frequency while keeping the average power about 2 orders of magnitude lower than the peak power. This results in a high plasma density, and high ionization fraction of the sputtered vapor, which allows better control of the film growth by controlling the energy and direction of the deposition species. This is a significant advantage over conventional dc magnetron sputtering where the sputtered vapor consists mainly of neutral species. The HiPIMS discharge is now an established ionized physical vapor deposition technique, which is easily scalable and has been successfully introduced into various industrial applications. The authors give an overview of the development of the HiPIMS discharge, and the underlying mechanisms that dictate the discharge properties. First, an introduction to the magnetron sputtering discharge and its various configurations and modifications is given. Then the development and properties of the high power pulsed power supply are discussed, followed by an overview of the measured plasma parameters in the HiPIMS discharge, the electron energy and density, the ion energy, ion flux and plasma composition, and a discussion on the deposition rate. Finally, some of the models that have been developed to gain understanding of the discharge processes are reviewed, including the phenomenological material pathway model, and the ionization region model.

In this study, the effect on thin film growth due to an anomalous electron transport, found in high power impulse magnetron sputtering (HiPIMS), has been investigated for the case of a planar circular magnetron. An important consequence of this type of transport is that it affects the way ions are being transported in the plasma. It was found that a significant fraction of ions are transported radially outwards in the vicinity of the cathode, across the magnetic field lines, leading to increased deposition rates directly at the side of the cathode (perpendicular to the target surface). Furthermore, this mass transport parallel to the target surface leads to that the fraction of sputtered material reaching a substrate placed directly in front of the target is substantially lower in HiPIMS compared with conventional direct current magnetron sputtering (dcMS). This would help to explain the lower deposition rates generally observed for HiPIMS compared with dcMS. Moreover, time-averaged mass spectrometry measurements of the energy distribution of the cross-field transported ions were carried out. The measured distributions show a direction-dependent high-energy tail, in agreement with predictions of the anomalous transport mechanism. (Some figures in this article are in colour only in the electronic version)

A new reactive ionization region model (R-IRM) is developed to describe the reactive Ar/O ₂ high power impulse magnetron sputtering (HiPIMS) discharge with a titanium target. It is then applied to study the temporal behavior of the discharge plasma parameters such as electron density, the neutral and ion composition, the ionization fraction of the sputtered vapor, the oxygen dissociation fraction, and the composition of the discharge current. We study and compare the discharge properties when the discharge is operated in the two well established operating modes, the metal mode and the poisoned mode. Experimentally, it is found that in the metal mode the discharge current waveform displays a typical non-reactive evolution, while in the poisoned mode the discharge current waveform becomes distinctly triangular and the current increases significantly. Using the R-IRM we explore the current increase and find that when the discharge is operated in the metal mode Ar ⁺ and Ti ⁺ -ions contribute most significantly (roughly equal amounts) to the discharge current while in the poisoned mode the Ar ⁺ -ions contribute most significantly to the discharge current and the contribution of O ⁺ -ions, Ti ⁺ -ions, and secondary electron emission is much smaller. Furthermore, we find that recycling of atoms coming from the target, that are subsequently ionized, is required for the current generation in both modes of operation. From the R-IRM results it is found that in the metal mode self-sputter recycling dominates and in the poisoned mode working gas recycling dominates. We also show that working gas recycling can lead to very high discharge currents but never to a runaway. It is concluded that the dominating type of recycling determines the discharge current waveform.