Direct solar‐powered hydrogen generation (so‐called “green” hydrogen) is promising as a renewable fuel that can be generated anywhere there is sunshine and water. Many attempts are made to integrate a water electrolyzer (EC) and solar cell at different levels (a so‐called artificial leaf) to take advantage of the reduced losses from the lack of wiring and optionally increased portability afforded by an integrated unit. However, in many cases, EC catalysts degrade as electrodes depolarize when shut down at night. Much less attention is paid to the need for a minimum current across the EC under insufficient illumination to prevent excessive cyclic degradation. Directly coupling a battery to keep an artificial leaf running at night can address this need and, in theory, also increase solar‐to‐hydrogen (STH) efficiency. A seven‐cell silicon heterojunction module, two bifunctional NiFeMo ECs in series, and a commercial Li‐ion NMC battery are selected to provide the same amount of solar output power despite different working voltages and tested in a series of simulated diurnal cycles. The increased average STH efficiency per cycle (11.4% vs. 10.5% without the battery) is analyzed and discussed with implications for future artificial leaf design and implementation.
Solar photovoltaic (PV) energy generation is highly dependent on weather conditions and only applicable when the sun is shining during the daytime, leading to a mismatch between demand and supply. Merging PVs with battery storage is the straightforward route to counteract the intermittent nature of solar generation. Capacity (or energy density), overall efficiency, and stability at elevated temperatures are among key battery performance metrics for an integrated PV-battery system. The performance of high-capacity silicon (Si)/graphite (Gr) anode and LiNi0.6Mn0.2Co0.2O2 (NMC622) cathode cells at room temperature, 45, and 60 °C working temperatures for PV modules are explored. The electrochemical performance of both half and full cells are tested using a specially formulated electrolyte, 1 M LiPF6 in ethylene carbonate: diethyl carbonate, with 5 wt % fluoroethylene carbonate, 2 wt % vinylene carbonate, and 1 wt % (2-cyanoethyl)triethoxysilane. To demonstrate solar charging, perovskite solar cells (PSCs) are coupled to the developed batteries, following the evaluation of each device. An overall efficiency of 8.74% under standard PV test conditions is obtained for the PSC charged lithium-ion battery via the direct-current-direct-current converter, showing the promising applicability of silicon/graphite-based anodes in the PV-battery integrated system.
8 October 2024 in Journal of Materials Chemistry A
Generalized framework for the design of indoor power units for autonomous Internet of Things (IOT) devices results in record efficiency combination of organic PV and sodium ion battery.