1 March 2017 in Journal of Materials in Civil Engineering
To highlight the influence of cement addition on laboratory characterization of lateritic gravel and the feasibility of cement–lateritic gravel for use in base construction, relatively comprehensive laboratory experiments were carried out on cement–lateritic gravels from République du Mali in Africa. It is shown, that although natural laterite gravels were gap-graded due to the lack of sand-sized and silt-sized particles, the aggregate breakdown and addition of cement would change the gradation and that the cement–lateritic gravel met the strength requirement for base-course construction in Africa. However, low contents of clay mineral properties of the fine grains in lateritic gravel resulted in the ineffectiveness of the cement reactions between lateritic gravel and cement, and then cement–lateritic gravels had poor water stability.
13 December 2022 in Advances in Materials Science and Engineering
A critical problem in the development and application of orthotropic steel bridge decks (OSDs) is fatigue cracking, which is determined by the deck’s structural system, mechanical characteristics, load, and external environmental factors. The development of bridge deck systems with high fatigue resistance is increasingly gaining interest in the field of bridge deck design. An effective method for improving the fatigue life of OSDs is the introduction of an ultra high performance concrete (UHPC) layer to enhance OSD’s stiffness. In this study, two types of experiments were performed to investigate the transverse and longitudinal fatigue behaviors of a steel–UHPC composite bridge deck with large longitudinal ribs. The experiments show that the application of a 70-mm-thick UHPC layer effectively reduces the stress intensity at key fatigue details in OSDs. The influence of the UHPC layer on the OSD fatigue performance was evaluated by experiments and finite element analysis. After the formation of microcracks on the UHPC surface layer, the composite bridge deck system continued to exhibit adequate fatigue performance. Moreover, the effects of damage accumulation on the UHPC layer and studs in transverse specimens were evaluated.