Electrocoagulation technique using aluminum electrodes in a batch bi-polar system was investigated to determine the efficiency of removing oil from oily wastewater. The Box–Behnken design was utilized to optimize conditions and the effects of four independent factors, including oil volume (X1), temperature (X2), initial pH (X3), and treatment time (X4),—were examined to investigate turbidity recovery and conductivity changes. The significant independent variables and their interactions were assessed using ANOVA. The optimal operating conditions for turbidity removal were obtained at an oil volume of 10 ml L−1, a temperature of 28 °C, an initial pH of 4, and a coagulation time of 90 min. The results revealed that turbidity removal and conductivity changes are enhanced significantly with increasing treatment time and decreasing oil volume. The application of the treatment process under optimal operating conditions allows promising removal efficiencies of 97.3%, and 73.4% for turbidity and conductivity, respectively. Also, the treated wastewater showed remarkable changes in removal efficiencies of the main oily wastewater pollution loads for COD, NO2, PO4, DO, and BOD. The economic study indicated that oily wastewater treatment by electrocoagulation is a very cost-effective technique.
Electrocoagulation-flotation (ECF) process evades many of the defects of chemical processes and considered as a simple low coast one for fluoride removal. The present work deals with defluoridation of different sodium fluoride solutions of both analar (AR) and commercial grades using bipolar and monopolar ECF. The effect of different variables on the defluoridation process; the initial fluoride solution concentration, speed of agitation, number of electrodes and distances between them, volume of solution, time of experiment, presence of additives and coexisting anions were studied. Complete removal is obtained after 5 min for AR grade (5 mg l−1) and for commercial (4.93 mg l−1) solutions without adding any additives. Monopolar configuration showed more effective removal than the bipolar one. This method is considered as a perfect one in the removal of high concentrations of fluoride in AR and commercial solutions in short time with no environmental risk and can be used in the industrial field. Data was analyzed using statistical programs trying to derive a modeling equation representing the conditions of defluoridation process.
1 June 2025 in Environmental Science and Pollution Research
The present study focuses on the effect of discharged wastes on the precipitation of some minerals (calcite, aragonite, dolomite, fluorite and sellaïte) as well as the chemical composition of seawater water columns along the eastern Egyptian Mediterranean Sea coast. This coast is subjected to different discharge waters containing agricultural, industrial, sewage and domestic wastes coming from the Nile River, the North Lakes as well as other different outlets. Variable levels of physicochemical parameters including temperature (T; 15.34–23.12°C), salinity (38.50–40.33%), pH (8.05–8.31), bicarbonate (HCO3; 63.73–147.22 mg/l), carbonate (CO3; 10.01–23.34 mg/l), calcium (Ca; 263.68–791.05 mg/l), magnesium (Mg; 799.67–2452.32 mg/l) and fluoride (F; 0.56–4.76 mg/l) were measured. Amongst the mineral production values that were calculated by saturation index (SI), fluorite and sellaïte calculations almost showed values <1, especially in the Rosetta and Damietta sectors which are affected by the Nile River. Marine organisms were influenced by the change in the physicochemical parameters along the investigated coastal area and showed aragonite and high-Mg calcite formation. Obviously, the statistical analyses of correlation matrix, ANOVA: two-factor without replication and stepwise regression of the present data explored the effect of the discharged effluents on the minerals formation and the chemical composition of seawater along the studied area. Additionally, the results showed the possible public health hazard from marine organism’s ingestion and seawater contact along the polluted areas. Accordingly, it seems advisable to reduce the pollution by discharged wastes into the Egyptian coastal ecosystems.
30 November 2024 in Egyptian Journal of Aquatic Research