8 April 2025 in Nature Communications
Multicomponent oxides, such as many minerals and high entropy oxides, show promise as materials for protection in extreme environments. Similar to other phononically dominated materials, the spectrum of vibrational carriers and phonon scattering heavily influences thermal transport in multi-cation oxides. In this work, we experimentally and computationally investigate the nature of phonon scattering and thermal transport in a series of single and multi-cation rare earth sesquioxides and zirconates. A reduction in thermal conductivity was observed from the single to multi-cation oxides, which is directly correlated to measured optical mode lifetimes. Via spectroscopic ellipsometry, we observe red shifting of the optical modes from local bonding distortion. Density functional theory calculation was used to evaluate how bonding distortions influence the phononic scattering rate observed through modal broadening and reduced thermal conductivity. Compared to single-cation oxides, the multi-cation oxides, especially those with larger cation size variance, exhibited lower effective coordination number and greater bond distortion.
13 May 2024 in Applied Physics Letters
Aluminum scandium alloys and their intermetallic phases have arisen as potential candidates for the next generation of electrical interconnects. In this work, we measure the in-plane thermal conductivity and electron–phonon coupling factor of aluminum scandium alloy thin films deposited at different temperatures, where the temperature is used to control the grain size and volume fraction of the Al3Sc intermetallic phase. As the Al3Sc intermetallic formation increases with higher deposition temperature, we measure increasing in-plane thermal conductivity and a decrease in the electron–phonon coupling factor, which corresponds to an increase in grain size. Our findings demonstrate the role that chemical ordering from the formation of the intermetallic phase has on thermal transport.
14 August 2026 in SSRN Electronic Journal
Ytterbium disilicate (Yb2Si2O7: YbDS) is a wide-bandgap, high-melting-temperature, polar material widely used as the primary thermal and environmental barrier coating for silicon carbide composites deployed in the hottest regions of advanced gas turbine engines. These coatings are exposed to a substantial radiative flux spanning the ultraviolet through the mid-infrared as well as to convective heating. To assess the significance of radiative heating from combustion gas emissions, the complex dielectric function of polycrystalline YbDS has been characterized from ambient to 1,000 °C using infrared spectroscopic ellipsometry and Fourier transform infrared spectroscopy. Density functional theory calculations of the zone-center phonon modes, combined with Born effective charge calculations, were used to identify the infrared-active phonon modes responsible for the observed spectral features. The measured intrinsic optical properties have enabled the fractions of incident flux that are reflected, transmitted, absorbed, and re-emitted by YbDS coating materials to be deduced. These fractions are strongly wavelength-dependent in the near and mid-infrared but are only weakly influenced by temperature. The experimental measurements reveal that YbDS has a low reflectance and is highly transparent in the 2-5 μm wavelength region, indicating that coating-protected SiC components are vulnerable to radiative heating by combustion gases. The phonon calculations show that the spectral location of the transparency window results from those of the longitudinal and transverse optical phonon modes. Their wavelengths are determined by displacements of the Si-O bonds whose stiffness and effective ion mass are intrinsic properties of the disilicate sublattice and effected little by the lanthanide ion.