1 December 2022 in International Journal of Power Electronics and Drive Systems (IJPEDS)
Solar photovoltaic (PV) system becomes popular to generate the electricity in Asian region and helps to reduce the burden to utility. The power converter plays crucial role to interconnect with DC- grid. Traditional type power DC-DC converter can able to extract the maximum power from solar PV. However, most of the applications, it often fails to meet the voltage level of the DC bus and additional converter is required to boosting p the DC voltage. In order to overcome this drawback, this paper proposes a novel DC-DC converter to extract the maximum power from solar PV and helps to enhance the voltage level to meet the DC-bus. The PV and IV characteristics of practical solar PV cell and mathematical modelling have been done and implemented the same to proposed high gain converter. The maximum power point tracking (MPPT) algorithm and operation details are addressed and the detailed operation waveform of proposed high voltage gain DC-DC converter with mathematical evident is reported in this paper. The simulation study was carried out in the PSCAD/EMDTC software. From the measured results, it is investigated in further to validate the MPPT operation, gain values achievement and performance analysis of proposed converter. The corresponding explanations and results are presented in this article.
1 November 2021 in Journal of Physics: Conference Series
The prescribed algorithm for removing impulse noise effectively even under high noise densities without causing any loss of image details. Hence a cascaded section of median filters that, involves an Decision-based Median Filter followed by a Recursive Weighted Median (RWM) Filter employing exponential weights are used. The median controlled algorithm is employed to calculate the exponential weights. In the algorithms that where proposed in earlier which involves a cascaded section of the median with the RWM filters provided lesser Peak Signal/Noise Ratio (PSNR) and greater Mean Square Error(MSE) values. Hence the output appeared to be distorted for higher noise levels. These drawbacks have been eliminated in this proposed algorithm.
15 November 2015 in IJIREEICE
1 May 2021 in Journal of Physics: Conference Series
In this paper, a seven-level cascaded H-Bridge dynamic voltage restorer (CHDVR) is proposed to mitigate power quality issues in the power system that are causing severe problems both in industrial and commercial sectors which may sometimes lead to interruption of power. To improve the voltage quality, many series compensators are been using in which DVR is one best solution wherein in many cases phase angle jump is not considered during the initial stage of compensation which influences the power quality. In this paper voltage Phase Angle Jump (PAJ) is taken into consideration to improve voltage quality using DVR. Moreover, Fault riding capability (FRC) is also considered along with phase jump to progress overall execution of the power system. The control strategy adopted is worked out for several sag cases and the analysis is validated using results acquired from MATLAB/SIMULINK 2019 platform.