Recently, it has been shown that, like β-rhombohedral boron (β-boron), α-rhombohedral boron (α-boron) exhibits superconductivity at high pressure. The transition pressure is similar to that of β-boron, that is, about 160 GPa. This paper presents a theoretical and experimental study of the structural change in α-boron at high pressures. High-pressure (up to 200 GPa) X-ray experiments were performed at a synchrotron-radiation facility. At ambient temperature, the crystal of α-boron is stable over the whole range of pressures examined. There is no phase transitions, such as to α-Ga type, which were previously predicted. All the structural parameters vary continuously with pressure. The cause of metallization is a significant contraction of the inter icosahedral three-center bond, which brings a higher coordination to the icosahedron and a transfer of charge from the intra icosahedoral bond to the three-center bond. Although everything is continuous, a careful analysis of the pressure dependence of the struct...
The lattice thermal conductivity (κlat) of MgSiO3 postperovskite (Mg‐PPv) under the lowermost mantle pressure (P) and temperature (T) conditions was calculated using density functional theory combining anharmonic lattice dynamics theory. The κlat of Mg‐PPv was found to be ~50% higher than that of MgSiO3 bridgmanite (Mg‐Brg) owing to the larger phonon group velocity and lifetime. The lateral variation in the core‐mantle boundary heat flux (qCMB) can be enhanced by the Brg‐PPv phase transition. We also found that the κlat along the c axis of Mg‐PPv is close to the conductivity of isotropic aggregate. This suggests that the effect of anisotropy in the κlat on qCMB would be minor if the transversely isotropic aggregate with the c axis vertical alignment, a potential source of seismic anisotropy in the D″ layer, is developed.
1 June 2009 in Journal of Physics: Conference Series
The effects of iron (Fe) incorporation on the lattice thermal conductivity ( ) of MgO are investigated under the Earth’s lower mantle pressure (P) and temperature (T) condition (P > ∼20 GPa, T > ∼2000 K) based on the density-functional theory combined with the anharmonic lattice dynamics theory. The of ferropericlase (FP) is determined combining the internally consistent LDA + U method and self-consistent approach to solve the phonon Boltzmann transport equation. The calculated are well fitted to the extended Slack model which is proposed in this study to represent in a wide volume and T range. Results demonstrate that the of MgO decreases strongly by Fe incorporation. This strong negative effect is found due to decreases in phonon group velocity and lifetime. Consequently, the of MgO at the core-mantle boundary condition (P∼ 136 GPa, T ∼ 4000 K) is substantially reduced from ∼40 to ∼10 W m−1 K−1 by the incorporation of Fe (12.5 mol%). The effect of Fe incorporation on the of MgO is found to be insensitive to P and T, and at high T, the of FP obeys a well-established T inverse relation unlike the experimental observations.