The thermoelectric power factor of SrTiO3 is unusually high with respect to its mobility and band gap. Good thermoelectrics usually have high mobility and a narrow band gap, but such properties are not found in SrTiO3. We have determined the mechanism behind the high power factor by calculating the transport coefficients. The key to understanding the power factor is that different effective masses contribute to different transport phenomena. The discrepancy between the effective mass for the conductivity and the thermoelectric power showed that the conductivity and thermoelectric power are conveyed by electrons with different effective masses in the Brillouin zone. Light electrons were responsible for the high conductivity, whereas heavy electrons were responsible for the high thermoelectric power. The high carrier concentrations of more than 1020 cm−3 did not reduce the thermoelectric power of SrTiO3 above the classical limit. This indicates that the electrons carrying the thermoelectric power were not degenerate. This is achieved by a decrease in the Fermi energy and the contribution of the heavy electrons to the Seebeck coefficient. The strong dielectric screening also contributed to the high power factor. The Coulomb scattering by ionized impurities, which would usually reduce the carrier mobility, was effectively screened. These results clarify the mechanism behind the contribution of different types of electrons, and show that high thermoelectric power does not necessarily reduce conductivity. Our findings provide a new direction for the band engineering of thermoelectric materials.
We have resolved long-standing discrepancies between the theoretical and experimental crystal structures of boron carbide . Theoretical studies predict that should be stoichiometric and have the highest symmetry of the boron carbides. Experimentally, is a semiconductor and many defect states have been reported, particularly in the CBC chain. Reconciling the disordered states of the chain, the chemical composition, and the lowest-energy state is problematic. We have solved this problem by constructing a structural model where approximately three-quarters of the unit cells contain (CBC) and one-quarter of them contain . This structural model explains many experimental results, such as the large thermal factors in x-ray diffraction and the broadening of the Raman spectra, without introducing unstable CBB chains. The model also solves the energy-gap problem. We show that there are many arrangements of these two types of unit cells, which are energetically almost degenerate. This demonstrates that boron carbides are well described by a geometrically frustrated system, similar to that proposed for -rhombohedral boron.
Recently, it has been shown that, like β-rhombohedral boron (β-boron), α-rhombohedral boron (α-boron) exhibits superconductivity at high pressure. The transition pressure is similar to that of β-boron, that is, about 160 GPa. This paper presents a theoretical and experimental study of the structural change in α-boron at high pressures. High-pressure (up to 200 GPa) X-ray experiments were performed at a synchrotron-radiation facility. At ambient temperature, the crystal of α-boron is stable over the whole range of pressures examined. There is no phase transitions, such as to α-Ga type, which were previously predicted. All the structural parameters vary continuously with pressure. The cause of metallization is a significant contraction of the inter icosahedral three-center bond, which brings a higher coordination to the icosahedron and a transfer of charge from the intra icosahedoral bond to the three-center bond. Although everything is continuous, a careful analysis of the pressure dependence of the struct...