In this study, we propose a new post processing algorithm, using a stable low-rank decomposed pseudo restored heat flux based on the ensemble variational Bayes tensor factorization (EVBTF-RPHF) algorithm for performing periodic square wave thermographic nondestructive testing (thermographic NDT). Previous studies have shown that both RPHF and EVBTF can separately improve the detectability of thermography by enhancing some defect features. However, both methods are limited by their particularly constraints: RPHF are heavily degraded by noises and missing data due to the assumptions under which the physical models are derived while efficiency of EVBT reduces when the lateral heat diffusion weights out. By embedding RPHF into the stable low-rank decomposition EVBTF, the proposed algorithm allows to improve the detectability of defects in thermographic NDT using a periodic heat flux with low-rank spatial distribution. The study verifies the capacity of the proposed method by theoretical analysis. Then, experiments were conducted on a carbon fiber composite panel with foreign inserts buried up to 5 mm deep. The sampled data are processed by the proposed method. The results are compared with existing methods such as phase-locked RPHF and EVBTF. The experimental results demonstrated that defects with normalized diameter-to-depth ratios as small as 0.9, barely detected with other available techniques, can reliably be detected by EVBTF-RPHF. The signal to noise ratio and the contrast are used as figure of merit to quantitatively compare the capacity of the proposed method with existing methods. However, the computation efficiency of the proposed algorithms needs further improvement.
The size of debonding between substrates and coatings are difficult to be accurately evaluated in vibro-thermography due to its complex mechanism. This paper proposes a method for quantitatively evaluating the area of debonding defects in coating systems based on ultrasonic thermography and a delamination area compensation model for defect segmentation in ultrasonic thermography of coating systems. The proposed method then has been derived and tested based on experimental data sampled from a coated aluminium alloy specimen and those from a coated carbon fiber reinforced polymer specimen, respectively. Deconvolution reconstruction based on the LR algorithm has been used to process thermal images to reduce the effect of diffusion in the transverse direction to enhance defect characterization in infrared images. Binary graphs after threshold segmentation have been compensated by the least square nonlinear curve fitting method to evaluate defect areas. The experimental results have shown that the proposed method can clearly detect debonding defects with the diameter-to-depth ratio as small as 2.5 and nondestructively evaluate areas of debonding defects, the relative measurement error of areas of debonding defects in the coated aluminium alloy specimen being 4.71%, and the relative error of the coated CFRP specimen being 10.29%.