Sergio E. Flores-Villaseñor

Sergio E. Flores-Villaseñor

Auto-generated profile, based on publicly available information

Sergio E. Flores-Villaseñor

Facultad de Metalurgia, Universidad Autónoma de Coahuila, Carr. 57, km 4.5, Monclova CP 25710, Mexico

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 December 2022 in Coatings
Verified
Journal Article
Open access
PDF file
EBEgberto Bedolla-Becerril
Egberto Bedolla-Becerril
JGJosefina Garcia-Guerra
Josefina Garcia-Guerra
VMVictor Hugo Morelos
Victor Hugo Morelos
MRMarco Arturo García Rentería
Marco Arturo García Rentería
LFLazaro Falcon-Franco
Lazaro Falcon-Franco
SFSergio E. Flores-Villaseñor
Sergio E. Flores-Villaseñor
Pin-on-disk tests were performed to evaluate the wear behaviour of a 2024 aluminium alloy metal matrix composite (MMC) reinforced with 52 vol.% of TiC particles (Al-2024/TiC) in a fabricated and thermal-treated (T6) condition. The MMC was produced via pressureless infiltration of partially sintered TiC preforms with an average particle size of 1.1 μm at 1200 °C for 2 h under flowing argon. Microstructural and mechanical characterisation were carried out on both the monolithic alloy (MM) and the MMC with and without heat treatment. The effect of T6 heat treatment on the tribological behaviour of MMC has been investigated under dry sliding wear conditions under normal loads of 2, 5 and 10 N against ceramic α-Al2O3 and SAE 52100 steel spherical counterparts. Results indicate a substantial improvement in the microhardness (289–343 HV), hardness (25–34 HRC), and wear resistance of the MMC after T6 heat treatment (1 × 10−3 to 5 × 10−5 mm3/Nm). For a better understanding of the wear mechanisms, surfaces of the worn tracks were studied. Oxidation and abrasion were found as the dominant wear mechanisms in both MM and MMC samples. Even though MM exhibited a lower coefficient of friction (COF) (0.50–0.80), composites showed superior wear resistance by 5-fold higher than the base alloy.