Pin-on-disk tests were performed to evaluate the wear behaviour of a 2024 aluminium alloy metal matrix composite (MMC) reinforced with 52 vol.% of TiC particles (Al-2024/TiC) in a fabricated and thermal-treated (T6) condition. The MMC was produced via pressureless infiltration of partially sintered TiC preforms with an average particle size of 1.1 μm at 1200 °C for 2 h under flowing argon. Microstructural and mechanical characterisation were carried out on both the monolithic alloy (MM) and the MMC with and without heat treatment. The effect of T6 heat treatment on the tribological behaviour of MMC has been investigated under dry sliding wear conditions under normal loads of 2, 5 and 10 N against ceramic α-Al₂O₃ and SAE 52100 steel spherical counterparts. Results indicate a substantial improvement in the microhardness (289–343 HV), hardness (25–34 HRC), and wear resistance of the MMC after T6 heat treatment (1 × 10⁻³ to 5 × 10⁻⁵ mm³/Nm). For a better understanding of the wear mechanisms, surfaces of the worn tracks were studied. Oxidation and abrasion were found as the dominant wear mechanisms in both MM and MMC samples. Even though MM exhibited a lower coefficient of friction (COF) (0.50–0.80), composites showed superior wear resistance by 5-fold higher than the base alloy.

In this study, the effect of martensite volume fraction on the mechanical, tribological, and corrosion properties of API 5CT dual-phase steel is studied based on intercritical heat treatment routes at different temperatures (730, 760, and 790 °C). Hardness of the specimens increased by increasing the martensite volume fraction up to 50%. Further increase in martensite volume fraction led to an increase in wear resistance. Sliding wear pin-on-disk tests were analyzed following the ASTM G99 standard, obtaining the wear rate, the volume of lost mass, and the Archard coefficient as a function of time and temperature of the heat treatment. A comparison was made between the wear rate and the hardness data, and its proportionality was established. The corrosion behavior of DP steels in 3.5% NaCl solution was studied by the potentiodynamic polarization technique. The result showed that with increasing the martensite amount in the specimen and decreasing the ferrite amount, the corrosion rate decreased. Finally, the corrosion mechanism in DP steel depends on the self-corrosion resistance behavior of both phases (martensite-ferrite) as well as the presence of galvanic corrosion between them.

In this work, different processing routes were investigated to evaluate the effects of hot rolling temperature, annealing before cold rolling (ABCR), and one- or two-stage cold rolling and annealing schedules to obtain more efficient electrical steels. The correlation between processing variables, microstructure, thickness, and magnetic properties was established from the analysis of 3D surface plots. It was found that the lowest core loss values (3.4 W/kg) were obtained when steel is processed by hot rolling (800 °C), ABCR (880 °C–180 min), first cold rolling (up to 0.25 mm), first annealing (850 °C–10 min), second cold rolling (up to 0.2 mm), and second annealing (850 °C–10 min). The better combination between thickness and grain size leads to the enhancement of the magnetic properties, which affects the way eddy and hysteresis losses contribute to the total core losses.