The research presented herein describes the preparation of electrospun homogeneous nanofibrous structures with customized morphology and properties, as well as textile support for necessary reinforcement for microfiltration applications. Findings report membranes comprising a polyurethane or fluorinated copolymer nanofibrous layer and polyethylene terephthalate nonwoven textile as support were evaluated. The investigation encompassed various constructions of materials, which include the influence of nanostructure morphology, the process of membrane cleaning by backwashing, and factors affecting flux, filtration efficacy, and working life. Application of membrane support made from polyethylene terephthalate with a large distribution of polymer chain provides a sufficiently strong connection with a layer of nanofibers with minimum penetration into the nanostructure involved in flux improvement. It was discerned that nanostructures with a morphology of six layers from thick (fiber diameter ~ 500 nm) and thin (fiber diameter ~ 180 nm) nanofibers with mean pore size 0.67 μm in comparison with membranes prepared from thin nanofibers only (mean pore size 0.26 μm) exhibited improved flux (17 times higher after 150 min of filtration process). In contrast, the filtration efficacy of both membranes for filtering submicron particles remained stable and highly efficient. It also proved to smooth out the surfaces of the novel membranes, which simplifies the removal of caked‐up debris. Cleaning the filter by backwashing renewed the efficacy of the developed membranes for filtration and extended their working life. Finally, repeatedly backwashing the thin nanofiber layer membrane raised the water flux measured as 230 L m−2 h−1, that is, six times higher than without backwashing.
15 September 2022 in Environmental Science: Water Research & Technology
This study investigates the effect of the nanofibrous polymeric structure of an adsorptive material, modified with an immobilized inorganic sorbent based on ferrous sulphate, on the capacity of the material to remove arsenic from contaminated water. Nanofibrous materials were prepared by electrospinning from polyurethane types selected using a primary adsorption test. The functional groups and chemical composition (FTIR, EDX), morphology (SEM, porometry) and hydrophilicity (contact angles) of the prepared nanostructured materials were determined in order to assess the effect of composition and structure on the removal of arsenic. The process of arsenic removal was monitored by atomic absorption spectroscopy (AAS). It was found that certain samples of polyurethanes, particularly self-synthesized aromatic polyurethane of an ester type, PU918, could remove arsenic by complexation on nitrogen in their polymer chains. The greatest efficiency for arsenic removal was ca. 60% (initial cAs = 150 μg L−1). It was also found that adding even a small amount (1 wt%) of an inorganic adsorbent based on ferrous sulphate into the fibre mass of the nanofibrous structure would increase the efficiency up to 90% as a result of a chemical reaction between the additive and arsenic ions. The extent and rate of adsorption were described by kinetic and isotherm models. The adsorption process is well characterized by a pseudo-second-order kinetic model and both Freundlich and Langmuir isotherm models. High adsorption capacity and rate are the basis for the use of nanofibrous material in filters for arsenic separation.