Native defects in semiconductors play an important role in their optoelectronic properties. Nickel oxide (NiO) is one of the few wide-gap p-type oxide semiconductors and its conductivity is believed to be controlled primarily by Ni-vacancy acceptors. Herein, we present a systematic study comparing the optoelectronic properties of stoichiometric NiO, oxygen-rich NiO with Ni vacancies (NiO:VNi), and Ni-rich NiO with O vacancies (NiO:VO). The optical properties were obtained by spectroscopic ellipsometry, while valence band spectra were probed by high-resolution x-ray photoelectron spectroscopy. The experimental results are directly compared to first-principles density functional theory + U calculations. Computational results confirm that gap states are present in both NiO systems with vacancies. Gap states in NiO:Vo are predominantly Ni 3d states, while those in NiO:VNi are composed of both Ni 3d and O 2p states. The absorption spectra of the NiO:VNi sample show significant defect-induced features below 3.0 eV compared to NiO and NiO:VO samples. The increase in sub-gap absorptions in NiO:VNi can be attributed to gap states observed in the electronic density of states. The relation between native vacancy defects and electronic and optical properties of NiO are demonstrated, showing that at similar vacancy concentration, the optical constants of NiO:VNi deviate significantly from those of NiO:VO. Our experimental and computational results reveal that although VNi are effective acceptors in NiO, they also degrade the visible transparency of the material. Hence, for transparent optoelectronic device applications, an optimization of native VNi defects with extrinsic doping is required to simultaneously enhance p-type conductivity and transparency.
Nickel oxide, NiO, is an important -type oxide semiconductor that has been studied for applications in solar cells, junction diodes, and other optoelectronic devices. In a nominally undoped NiO, depending on its oxygen stoichiometry, it only has a modest -type conductivity of ∼0.1 S/cm due to Ni vacancy acceptors. However, the overall transport can be improved by extrinsic doping. In this study, we carry out a combined experiment and computational study of the effects of acceptor dopants, including Li, Ag, and Cu on the properties of NiO. Our ab initio calculations show that among all the acceptors studied, substitutional Li () acceptor species has the lowest formation and ionization energies. Measured electrical properties of the undoped and doped oxygen-rich NiO () show an increase in conductivity and hole concentration for the doped samples. In particular, Li is an efficient acceptor to achieve highly conducting -type NiO with >40% transmittance in the visible range for a 100-nm-thick film. The improvement in the electrical properties with different dopant species studied is in good agreement with the calculated defect formation and ionization energies. A remarkable increase in the temperature-dependent Hall mobility is also observed in the doped samples. Based on the small-polaron hoping model, we analyzed the conduction mechanism in the doped samples, which revealed a hopping dominated activation with energies in the range of 172–208 meV.
21 July 2021 in ACS Applied Materials & Interfaces
Beta gallium oxide (β-Ga2O3)-based semiconductor heterojunctions have recently demonstrated improved performance at high voltages and elevated temperatures and are, thus, promising for applications in power electronic devices and harsh environment sensors. However, the long-term reliability of these ultra-wideband gap (UWBG) semiconductor devices remains barely addressed and may be strongly influenced by chemical reactions at the p–n heterojunction interface. Here, we experimentally demonstrate operation and evaluate the reliability of Cr2O3:Mg/β-Ga2O3 p–n heterojunction diodes during extended operation at 600 °C, as well as after 30 repeated cycles between 25 and 550 °C. The calculated pO2-temperature phase stability diagram of the Ga-Cr-O material system predicts that Ga2O3 and Cr2O3 should remain thermodynamically stable in contact with each other over a wide range of oxygen pressures and operating temperatures. The fabricated Cr2O3:Mg/β-Ga2O3 p–n heterojunction diodes show room-temperature on/off ratios >104 at ±5 V and a breakdown voltage (VBr) of −390 V. The leakage current increases with increasing temperature up to 600 °C, which is attributed to Poole–Frenkel emission with a trap barrier height of 0.19 eV. Over the course of a 140-h thermal soak at 600 °C, both the device turn-on voltage and on-state resistance increase from 1.08 V and 5.34 mΩ cm2 to 1.59 V and 7.1 mΩ cm2, respectively. This increase is attributed to the accumulation of Mg and MgO at the Cr2O3/Ga2O3 interface as observed from the time-of-flight secondary ion mass spectrometry analysis. These findings inform future design strategies of UWBG semiconductor devices for harsh environment operation and underscore the need for further reliability assessments for β-Ga2O3-based devices.
In this work, we report on the realization of SnO/β-Ga2O3 heterojunction vertical diodes and lateral field-effect transistors for power electronic applications. The p-type semiconductor SnO is grown by plasma-assisted molecular beam epitaxy on n-type (100) β-Ga2O3 with donor concentrations of 3 × 1017 cm−3 for the diode devices and 8.1 × 1017 cm−3 for the field-effect transistors. The deposited films show a predominant SnO (001) phase featuring a hole concentration and a mobility of 7.2 × 1018 cm−3 and 1.5 cm2/V s, respectively. The subsequent electrical characterization of the heterojunction diodes and field-effect transistors show stable switching properties with on/off current ratios >106 and specific on-resistances below 4 mΩ cm2. Furthermore, breakdown measurements in air of the non-field-plated heterojunction transistor with a gate-to-drain distance of 4 μm yield a breakdown voltage of 750 V, which equals an average breakdown strength of nearly 1.9 MV/cm. The resulting power figure of merit is calculated to 178 MW/cm2 demonstrating state-of-the-art properties. This emphasizes the high potential of this heterojunction approach.