The heteroepitaxial growth and phase formation of Ga2O3 on Al-polar AlN(0001) templates by molecular-beam epitaxy (MBE) are studied. Three different MBE approaches are employed: (i) conventional MBE, (ii) suboxide MBE (S-MBE), and (iii) metal-oxide-catalyzed epitaxy (MOCATAXY). We grow phase-pure β-Ga2O3(2̄01) and phase-pure ϵ/κ-Ga2O3(001) with smooth surfaces by S-MBE and MOCATAXY. Thin film analysis shows that the crystallographic and surface features of the β-Ga2O3(2̄01)/AlN(0001) and ϵ/κ-Ga2O3(001)/AlN(0001) epilayers are of high crystalline quality. Growth and phase diagrams are developed to synthesize Ga2O3 on AlN by MBE and MOCATAXY and to provide guidance to grow Ga2O3 on several non-oxide surfaces, e.g., AlN, GaN, and SiC, by MBE, S-MBE, and MOCATAXY.
Denisovite is a rare mineral occurring as aggregates of fibres typically 200–500 nm diameter. It was confirmed as a new mineral in 1984, but important facts about its chemical formula, lattice parameters, symmetry and structure have remained incompletely known since then. Recently obtained results from studies using microprobe analysis, X-ray powder diffraction (XRPD), electron crystallography, modelling and Rietveld refinement will be reported. The electron crystallography methods include transmission electron microscopy (TEM), selected-area electron diffraction (SAED), high-angle annular dark-field imaging (HAADF), high-resolution transmission electron microscopy (HRTEM), precession electron diffraction (PED) and electron diffraction tomography (EDT). A structural model of denisovite was developed from HAADF images and later completed on the basis of quasi-kinematic EDT data byab initiostructure solution using direct methods and least-squares refinement. The model was confirmed by Rietveld refinement. The lattice parameters area= 31.024 (1),b= 19.554 (1) andc= 7.1441 (5) Å, β = 95.99 (3)°,V= 4310.1 (5) Å3and space groupP12/a1. The structure consists of three topologically distinct dreier silicate chains,viz. two xonotlite-like dreier double chains, [Si6O17]10−, and a tubular loop-branched dreier triple chain, [Si12O30]12−. The silicate chains occur between three walls of edge-sharing (Ca,Na) octahedra. The chains of silicate tetrahedra and the octahedra walls extend parallel to thezaxis and form a layer parallel to (100). Water molecules and K+cations are located at the centre of the tubular silicate chain. The latter also occupy positions close to the centres of eight-membered rings in the silicate chains. The silicate chains are geometrically constrained by neighbouring octahedra walls and present an ambiguity with respect to theirzposition along these walls, with displacements between neighbouring layers being either Δz=c/4 or −c/4. Such behaviour is typical for polytypic sequences and leads to disorder along [100]. In fact, the diffraction pattern does not show any sharp reflections withlodd, but continuous diffuse streaks parallel toa* instead. Only reflections withleven are sharp. The diffuse scattering is caused by (100) nanolamellae separated by stacking faults and twin boundaries. The structure can be described according to the order–disorder (OD) theory as a stacking of layers parallel to (100).
We report on the computation of mean inner Coulomb potentials of technologically important wurtzite-type semiconductors AlN, GaN, InN, ZnO, and CdO and of gold within the density functional theory formalism. We used a slab geometry with (11–20) and (110) surfaces, respectively. Structures consisting of several monolayers of material and an adjacent vacuum region were generated and the Coulomb potential was computed using the full potential linearized augmented plane wave method. The mean inner Coulomb potential was obtained by computing the difference of the potentials averaged inside the innermost monolayer of the slab and within the center plane of the vacuum region.