This chapter contains sections titled: Introduction Thermodynamics of the Ring-Opening Polymerization Kinetics of Ring-Opening Polymerization Concluding Remarks References
Ultra High Molecular Weight Polyethylene (UHMWPE) has excellent properties, such as high mechanical performance, low friction, high wear and chemical resistance but so far there has been limited use in additive manufacturing (AM). Laser sintering of polymers is one of the most promising AM technologies due to its ability to produce complex geometries with accurate dimensions and good mechanical properties. Consequently, this study investigates the influence of laser power on physical and mechanical properties of UHMWPE parts produced by laser sintering. In particular mechanical properties, such as Ultimate Tensile Strength (UTS), Young’s Modulus and elongation at break were evaluated alongside relative density, dilation and shrinkage. Finally, the fracture surface of the tensile test specimens was examined by electron microscopy. Results show that within a laser power range of 6–12 W there appears to be an optimum where tensile strength and relative density reach a maximum, dilation is minimised and where elongation increases with laser power. UTS up to 2.42 MPa, modulus up to 72.6 MPa and elongation at break up to 51.4% were observed. Relative density and part dimensions are also influenced by laser power.
28 December 2021 in The Journal of Physical Chemistry Letters
The equilibrium constant (K) of biochemical complex formation in aqueous buffers with high concentration (>20 wt %) of nonionic compounds can vary by orders of magnitude in comparison with the K in a pure buffer. The precise molecular mechanisms of these profound changes are not known. Herein, we show up to a 1000-fold decrease of the K value of DNA hybridization (at nM concentration) in standard molecular crowder systems such as PEG, dextrans, Ficoll, and glycerol. The effect responsible for the decrease of K is the complexation of positively charged ions from a buffer by nonionic polymers/small molecules. We determined the average equilibrium constant for the complexation of ions per monomer (∼0.49 M–1). We retrieve K’s original value for a pure buffer if we properly increase the ionic strength of the buffer crowded by the polymers, compensating for the loss of complexed ions.
The reaction kinetics between like-charged compounds in water is extremely slow due to Coulomb repulsions. Here, we demonstrate that by screening these interactions and, in consequence, increasing the local concentration of reactants, we boost the reactions by many orders of magnitude. The reaction between negatively charged Coenzyme A molecules accelerates ~5 million-fold using cationic micelles. That is ~104 faster kinetics than in 0.5 M NaCl, although the salt is ~106 more concentrated. Rate enhancements are not limited to micelles, as evidenced by significant catalytic effects (104–105-fold) of other highly charged species such as oligomers and polymers. We generalize the observed phenomenon by analogously speeding up a non-covalent complex formation—DNA hybridization. A theoretical analysis shows that the acceleration is correlated to the catalysts’ surface charge density in both experimental systems and enables predicting and controlling reaction rates of like-charged compounds with counter-charged species.