Polarization-dependent gain (PDG) effect was studied in a conventional core-pumping configuration of bismuth-doped fiber amplifiers (BDFAs) based on PANDA-type phospho- and germanosilicate core fibers. The PDG value was determined as the gain difference between the orthogonal signal polarizations, which was found to be in range of 2.5–3 dB at total gain of >20 dB in such BDFAs. This effect is more pronounced for BDFA with a germanosilicate fiber. The experimental results are in a good agreement with the calculated data derived from the simulation model, relying on the anisotropy parameter of bismuth active centers (BACs) obtained from the degree of luminescence polarization, which ranges between 9 and 12% for BACs-Si and 18 and 22% for BACs-P. The obtained data can be useful for the optimization of performance of BDFAs and studying structural peculiarities of BACs.
We report on the development of a cladding-pumped ultra-broadband optical amplifier for a spectral region of 1260–1480 nm using a Bi-doped fiber (BDF) with heterogeneous core formed by combination of PO- and GeO-containing glass layers. This BDF design ensures a favorable local environment for the effective formation process of BACs associated with P and Si atoms. The BDF amplifier (BDFA) pumped into the cladding by multi-mode laser diodes at 793 and 808 nm is characterized by a peak gain of 24 dB, a minimum noise figure of 6 dB, and a bandwidth of 160 nm at a gain level of 20 dB. The effect of the parameters of the fiber design on the output characteristics of BDFA was analyzed by numerical simulation. The calculated data were in good agreement with the experimental ones, which allowed us to outline possible ways to improve the BDFA.
A bismuth-doped fiber laser emitting optical radiation near 1.46 µm in two orthogonally polarized modes is presented. The laser was realized in an all-polarization-maintaining (PM) fiber configuration based on a gain medium with bismuth active centers associated with Si atoms (BACs-Si) and a fiber Bragg grating providing high reflectivity of two orthogonal polarizations. The single- and dual-polarized laser oscillations were achieved in various configurations. The polar plots of the laser output power in each mode as a function of pump polarization angle were obtained and analyzed. The conditions for achieving lasing in single- and dual-polarized modes were determined. In addition, the numerical model taking into account absorption and emission cross-section anisotropies of BACs-Si is proposed to study the behavior of the laser characteristics. The research can be useful for designing fiber laser sources with controllable polarization properties.