Shuichi Noda

Shuichi Noda

Auto-generated profile, based on publicly available information

Shuichi Noda

National Institute of Advanced Industrial Science and Technology (AIST) 2 , Tsukuba, Ibaraki 305-8568, Japan

Research Focus & Metrics

Academic Career Length

38Years (1989-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 1998 in Japanese Journal of Applied Physics
Verified
Journal Article
Closed access
TTTetsuya Tatsumi
Tetsuya Tatsumi
HHHisataka Hayashi
Hisataka Hayashi
SMSatoshi Morishita
Satoshi Morishita
SNShuichi Noda
Shuichi Noda
MOMitsuru Okigawa
Mitsuru Okigawa
MIMasami Inoue
Masami Inoue
The radicals of capacitive plasmas actually used in mass production were analyzed using various measurement systems. The composition of radicals in bulk plasma depends on the gas chemistry, the dissociation process, and interaction with the wall. It is revealed that parent gas (C4F8) is dissociated by multiple collision with electrons according to τ·n e<σv>, where τ is the residence time, n e is the electron density, σ is the dissociation collision cross section and v is the electron velocity. A high-performance etching process, which can realize 0.09 µmφ contact holes with aspect ratio of 11, was achieved using a short residence time to suppress the excess dissociation and the control of deposition species through the addition of O2 to C4F8/Ar plasma as well as the reduction of the density of F radicals through the reaction with the Si wall.

1 July 2004 in Journal of Vacuum Science & Technology A
Verified
Journal Article
Closed access
SNShuichi Noda
Shuichi Noda
HNHirotomo Nishimori
Hirotomo Nishimori
TITohru Ida
Tohru Ida
TATsunetoshi Arikado
Tsunetoshi Arikado
KIKatsunori Ichiki
Katsunori Ichiki
SSSeiji Samukawa
Seiji Samukawa
A 50-nm-width metal-oxide-semiconductor (MOS) gate etching process was established using a recently-developed neutral-beam etching system by optimizing the gas chemistry and the electrode bias condition. In a comparison with poly-Si gate etching using either SF6 or Cl2 gas chemistries, opposite etching characteristics were observed in the pattern profile. Consequently, the use of a mixture of these gases was proposed in order to achieve fine control of the etching profiles. The energy of the neutral beam was increased by applying a 600 kHz rf bias to the bottom electrode. The rf bias was very effective in increasing the etch rate and the anisotropy of the poly-Si gates, with no deterioration of the neutralization efficiency. The oxide leakage current achieved for a MOS capacitor etched by the neutral beam was one order of magnitude lower than that achieved by conventional plasma etching.

1 September 1999 in Journal of Vacuum Science & Technology A
Verified
Journal Article
Closed access
HHHisataka Hayashi
Hisataka Hayashi
SMSatoshi Morishita
Satoshi Morishita
TTTetsuya Tatsumi
Tetsuya Tatsumi
YHYukinobu Hikosaka
Yukinobu Hikosaka
SNShuichi Noda
Shuichi Noda
THTyuji Hoshino
Tyuji Hoshino
To investigate the mechanism of C4F8 dissociation in parallel-plate-type plasma, we used several of the latest diagnostic tools and made extensive measurements of electrons, radicals, and ions under conditions that greatly suppressed the effects of plasma-surface interaction. These measurements showed that the amount of light fluorocarbon radicals and ions increased with increasing electron density. The dissociation of C4F8 was analyzed by using rate equations, after confirming the stability and uniformity of the plasma. The total dissociation rate coefficient of C4F8 was 1×10−8 cm3/s, and CF2 radicals were mainly generated from products of C4F8 dissociation. F was mainly generated from CF2 by electron-impact dissociation and lost by pumping. We could estimate that the C2F4 density was roughly comparable to the densities of CF and CF3, and that the surface loss probability of C2F4 increased with increasing electron density. C2F4 might play an important role in the etching because of its rich polymerization characteristics.

24 April 2017 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
YLYen-Ku Lin
Yen-Ku Lin
SNShuichi Noda
Shuichi Noda
CHChia-Ching Huang
Chia-Ching Huang
HLHsiao-Chieh Lo
Hsiao-Chieh Lo
CWChia-Hsun Wu
Chia-Hsun Wu
ECEdward Yi Chang
Edward Yi Chang
High-performance GaN metal-oxide-semiconductor high-electron-mobility transistors (MOSHEMTs) using Al 2 O 3 gate dielectric deposited by atomic layer deposition (ALD) and damage-free neutral beam etch (NBE) gate recess process for millimeter-wave power applications are demonstrated. The high-quality ALD Al 2 O 3 reduces the gate leakage current of the device and the NBE method eliminates the plasma-induced defects in the nitride materials. The MOSHEMT device fabricated exhibits a high maximum drain current density (I DS,max ) of 1.65 A/mm and a high peak extrinsic transconductance (g m.ext ) of 653 mS/mm. The MOSHEMT device also demonstrates excellent RF performances, including f T /f MAX = 183/191 GHz, NF min = 2.56 dB with G AS = 5.61 dB at 54 GHz, and an output power density of 2.7 W/mm associated with a power-added efficiency of 20.9% and a linear power gain of 9.4 dB at 38 GHz. To the best of our knowledge, the noise performance at 54 GHz is the best reported so far for the AlGaN/GaN HEMTs.

24 July 2006 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
Kazuhiko EndoKazuhiko Endo
Kazuhiko Endo
SNS. Noda
S. Noda
MMM. Masahara
M. Masahara
TKT. Kubota
T. Kubota
TOT. Ozaki
T. Ozaki
ESE. Suzuki
E. Suzuki
A high aspect ratio and damage-free vertical ultrathin channel for a vertical-type double-gate MOSFET was fabricated by using low-energy neutral-beam etching (NBE). NBE can completely eliminate the charge build-up and photon-radiation damages caused by the plasma. The fabricated FinFETs realize a higher device performance (i.e., higher electron mobility) than that obtained by using a conventional reactive-ion etching. The improved mobility is well explained by the NB-etched atomically flat surface. These results strongly support the effectiveness of the NB technology for nanoscale CMOS fabrication

12 April 2013 in Journal of Physics: Conference Series
Verified
Conference Paper
Closed access
SNS Noda
S Noda
HSH Shima
H Shima
HAHiroyuki Akinaga
Hiroyuki Akinaga