A GaN metal-insulator-semiconductor-high electron mobility transistor (HEMT) using hybrid ferroelectric charge trap gate stack (FEG-HEMT) is demonstrated for normally-OFF operation. The ferroelectric (FE) polarization increases the number of trapped charges in the HfON charge trapping layer, leading to high positive threshold voltage (V th ) shift for the normally-OFF device. Besides, under the positive bias temperature instability (PBTI) test, the internal electric field induced by FE polarization causes smoother slope of the conduction band in FE gate stack, resulting in better V th stability. With the proposed hybrid FE charge trap gate stack, the device exhibits a high V th of +2.71 V at I Dh = 1μA/mm, a high maximum current density of 820 mA/mm and low on-resistance (R ON ) of 11.1 Ω · mm. The FE device also shows good V th -temperature stability compared to the non-FE device results. Besides, a high current device with 40 A is also fabricated in this letter to demonstrate the feasibility of the proposed FEG-HEMT device for high power device application.
25 July 2018 in IEEE Journal of the Electron Devices Society
A normally-OFF GaN metal-insulator-gate high electron mobility transistors with fluorine doped gate insulator has been fabricated using standard ion implantation technique. Fluorine ions with negative charges were doped lightly into both the gate insulator and the partially recessed barrier layer, resulting in high positive threshold voltage ( ${V} _{\mathrm{ th}}$ ) for the device, meanwhile preserving low ON-resistance. Compared to the fluorine-free and recess-free device, only about 16% increase of ON-resistance was observed for the F − doped devices. The fabricated F − doped device exhibits a threshold voltage of +0.68 V at ${I} _{\mathrm{ DS}}= 5~\mu \text{A}$ /mm, a current density of 620 mA/mm, an OFF-state breakdown voltage of 800 V, and high ON/OFF current ratio of 10 10 . For thermal stability consideration of fluorine dopant, the ${V} _{\mathrm{ th}}$ -thermal stability test and positive bias temperature instability test were also discussed.
High-performance GaN metal-oxide-semiconductor high-electron-mobility transistors (MOSHEMTs) using Al 2 O 3 gate dielectric deposited by atomic layer deposition (ALD) and damage-free neutral beam etch (NBE) gate recess process for millimeter-wave power applications are demonstrated. The high-quality ALD Al 2 O 3 reduces the gate leakage current of the device and the NBE method eliminates the plasma-induced defects in the nitride materials. The MOSHEMT device fabricated exhibits a high maximum drain current density (I DS,max ) of 1.65 A/mm and a high peak extrinsic transconductance (g m.ext ) of 653 mS/mm. The MOSHEMT device also demonstrates excellent RF performances, including f T /f MAX = 183/191 GHz, NF min = 2.56 dB with G AS = 5.61 dB at 54 GHz, and an output power density of 2.7 W/mm associated with a power-added efficiency of 20.9% and a linear power gain of 9.4 dB at 38 GHz. To the best of our knowledge, the noise performance at 54 GHz is the best reported so far for the AlGaN/GaN HEMTs.
A high-performance E-mode hybrid ferroelectric charge storage gate (FEG) GaN HEMT with an innovative source-connected field plate (SCFP) structure is reported for the first time. The optimized E-mode FEG-HEMT implements a novel SCFP structure, which creates a cascode-like configuration with a D-mode GaN MISHEMT. This E-mode SCFP GaN FEG-HEMT has a positive V th of 2.81 V, a high I D,max of 757mA/mm, and a BV of 866 V. Dynamic R ON reduced 25% when operated at V DSQ = 400 V. ON-state stress tests also show improved current collapse phenomena. Additionally, to address the charge storage abilities of FEG-HEMTs, a multi-cycle OFF-state ( V DS = 300 V, V GS = 0 V) retention test was conducted. The SCFP FEG-HEMT showed 58.46% less V th shift percentage than the FEG-HEMT without field plates.
8 July 2019 in IEEE Transactions on Electron Devices
A GaN metal-insulator-semiconductor high electron mobility transistor (MIS-HEMT) using tri-gate architecture and hybrid ferroelectric charge trap gate stack is demonstrated for normally-off operation. Compared with the conventional planar device, the tri-gate device has the 2-D electron gas (2-DEG) channel exposed on the nanowire sidewalls, so that the trapped charges in the HfON charge trapping layer can easily deplete the channel from the sidewalls, leading to a high positive threshold voltage (V th ) to realize the normally-off operation. Moreover, through this electrostatic control on the sidewall, a high density of negative charge caused by hybrid ferroelectric charge trap gate stack with the optimized tri-gate structure, the tri-gate device can achieve normally-off GaN device with both low on-resistance (R ON ) and high positive V th . The designed tri-gate device exhibits a high V th of +2.61 V at current density (I DS ) = 1 μA/mm, a high maximum current density (IDS, MAX) of 896 mA/mm, a low R ON of 5.0 Ω·mm and a high breakdown voltage (BV) of 788 V. To the best of our knowledge, the proposed tri-gate device shows the lowest specific on-resistance (R ON ,SP) among reported normally off GaN device results with BV > 650 V.
13 April 2020 in IEEE Transactions on Device and Materials Reliability
The charge trapping effects on AlGaN/GaN HEMTs under UV illumination are investigated using the pulsed current-voltage (I-V) measurement method. The test samples are unpassivated Schottky-gate HEMTs and metal-insulator-semiconductor HEMTs (MIS-HEMTs) with SiN gate dielectric. For HEMTs, the dominant charge trapping sources are the surface trap states, whereas, for MIS-HEMTs, they are trap states in the SiN gate dielectric and GaN buffer. When these devices are shined with the UV light, the drain current increases apparently in both samples owing to the generated photocurrent. By combining the UV illumination and pulsed I-V measurement, we find out the UV light has less effect on the surface charge trapping in the unpassivated HEMTs. Moreover, in MIS-HEMTs, we observe the charge trapping in the SiN gate dielectric becomes more serious under UV illumination, whereas the charge trapping in the GaN buffer is suppressed significantly. These findings are important for designing a GaN-based HEMT for photonic applications. In addition, the different responses of the surface-, buffer-, and gate-dielectric-related charge trapping to the UV light suggest that it would be easier to distinguish the trap types by introducing the UV illumination during the pulse measurement.