8 February 2019 in ACS Catalysis
Lignin, which is a highly cross-linked and irregular biopolymer, is nature’s most abundant source of aromatic compounds and constitutes an attractive renewable resource for the production of aromatic commodity chemicals. Herein, we demonstrate a practical and operationally simple two-step degradation approach involving Pd-catalyzed aerobic oxidation and visible-light photoredox-catalyzed reductive fragmentation for the chemoselective cleavage of the β-O-4 linkage—the predominant linkage in lignin—for the generation of lower-molecular-weight aromatic building blocks. The developed strategy affords the β-O-4 bond cleaved products with high chemoselectivity and in high yields, is amenable to continuous flow processing, operates at ambient temperature and pressure, and is moisture- and oxygen-tolerant.
20 October 2021 in IEEE Transactions on Electron Devices
2-D-material channels enable ultimate scaling of MOSFET transistors and will help Moore's Law scaling for years. We demonstrate the state of both n- and p-MOSFETs using monolayer transition metal dichalcogenide (TMD) channels of sub-1 nm thickness and manufacturable CVD, molecular beam epitaxy (MBE), or seeded growth. nMOS devices on transferred MBE MoS₂ using novel contact metal show low variation, one of the lowest reported contact resistances ( $R_{c}$ ) of 0.4 kΩ ·μ m, low hysteresis, and good subthreshold swing (SS) of 77 mV/dec. pMOS devices using CVD WSe₂ show 89 mV/dec SS, best reported for pMOS on grown films, but on-current remains behind nMOS. We show $R_{C}$ is improved by 5x by using a bake process prior to contact metal deposition. Transfer-free, area-selective seeded growth techniques for WS₂ and MoS₂ are demonstrated as options for wafer-scale TMD channel growth. WS₂ transistors achieve 10 μA/μm on-current, highest reported on WS₂ using seeded growth. A new capacitance method is shown to monitor 2-D material contact interface quality. Gate-oxide interface engineering through metal seeding and atomic layer deposition (ALD) demonstrates that a single 2-D channel material can selectively make pMOS or nMOS transistors, alike Si CMOS, and can also be used as a method to achieve p-type doping. We compare back-gated bare channel devices with dual-gate devices and observe hysteresis-free operation and an improvement in mobility with proper passivation.
14 February 2014 in Scientific Reports
Corrosion of metal in biomedical devices could cause serious health problems to patients. Currently ceramics coating materials used in metal implants can reduce corrosion to some extent with limitations. Here we proposed graphene as a biocompatible protective film for metal potentially for biomedical application. We confirmed graphene effectively inhibits Cu surface from corrosion in different biological aqueous environments. Results from cell viability tests suggested that graphene greatly eliminates the toxicity of Cu by inhibiting corrosion and reducing the concentration of Cu2+ ions produced. We demonstrated that additional thiol derivatives assembled on graphene coated Cu surface can prominently enhance durability of sole graphene protection limited by the defects in graphene film. We also demonstrated that graphene coating reduced the immune response to metal in a clinical setting for the first time through the lymphocyte transformation test. Finally, an animal experiment showed the effective protection of graphene to Cu under in vivo condition. Our results open up the potential for using graphene coating to protect metal surface in biomedical application.
1 May 2019 in Chemistry of Materials
15 June 2016 in ACS Applied Materials & Interfaces
20 July 2021 in ACS Applied Materials & Interfaces