1 May 2016 in Journal of Crystal Growth
FSF. (Shadi) Shahedipour-Sandvik
F. (Shadi) Shahedipour-Sandvik
17 September 2018 in Journal of Applied Physics
We report on holistic and systemic approach of development of Cs-free GaN photocathode structures which utilize polarization band engineering in order to allow for air stable operation and eliminate the need for cesium-based surface treatments. Physics-based simulation of band structure and Monte Carlo simulation of electron transport and emission were used to guide experimental development of photocathode structures. By using an N-polar device, the polarization charge allows for the creation of large surface band bending without the need for δ-doped capping layers. The insertion of a thin AlN interlayer allows for the creation of a quasi-band offset and additional beneficial polarization charge to create a desirable band profile. Samples of both polarities were grown and subjected to chemical surface treatments in order to account for differences in native oxide formation on Ga- and N-polar surfaces. Measured photoemission spectra show quantum efficiencies as high as 23% for a HCl-treated Cs-free N-polar photocathode, which is comparable to cesiated devices.
30 May 2017 in Journal of Electronic Materials
18 December 2014 in IEEE Photonics Technology Letters
FSF. Shadi Shahedipour-Sandvik
F. Shadi Shahedipour-Sandvik
+3
We report on the development of ion implantationbased contact-edge termination technique to improve the reliability and performance of p-i-n and p-i-n-i-n GaN ultraviolet avalanche photodiode structures. The GaN photodiode structures were grown on sapphire substrates and implanted along the edge of the p-contact. The implanted devices show an absence of premature breakdown and demonstrate a lower dark-current with reliable ultraviolet photoresponse, compared with the standard unimplanted devices. Device simulations of the implanted structures at the breakdown voltage, show a reduction in crowding and spiking of the electric field along the perimeter of the contact by a factor of ~7, compared with the unimplanted structures.
28 March 2018 in Journal of Applied Physics
We report on the development and verification of a Monte Carlo simulator for III-nitride photocathode structures. Due to the complexity of the process, attributing experimental photoemission results to physical origins can be difficult. We discuss the distribution of emitted electrons, including physical contributions for the shape and implications for device design. Although the Monte Carlo technique has shown promise in GaAs photocathodes, uncertainty in III-nitride band parameters makes simulation difficult. Here, a range of satellite valley band parameters were studied in the context of photoemission and compared to experimental results. We find that contrary to most published studies for Monte Carlo of III-nitrides, a lower effective mass in the satellite valley gives a closer match to experimental results.
19 October 2016 in Journal of Applied Physics
The surface photovoltage (SPV) technique was used to study the surface and electrical properties of Mg-doped, p-type AlxGa1−xN (0.06 < x < 0.17) layers. SPV measurements reveal significant deviation from previous SPV studies on p-GaN:Mg thin films and from the predictions of a thermionic model for the SPV behavior. In particular, the SPV of the p-AlGaN:Mg layers exhibited slower-than-expected transients under ultraviolet illumination and delayed restoration to the initial dark value. The slow transients and delayed restorations can be attributed to a defective surface region which interferes with normal thermionic processes. The top 45 nm of the p-AlGaN:Mg layer was etched using a reactive-ion etch which caused the SPV behavior to be substantially different. From this study, it can be concluded that a defective, near-surface region is inhibiting the change in positive surface charge by allowing tunneling or hopping conductivity of holes from the bulk to the surface, or by the trapping of electrons traveling to the surface by a high concentration of defects in the near-surface region. Etching removes the defective layer and reveals a region of presumably higher quality, as evidenced by substantial changes in the SPV behavior.