Emma Rocco

Emma Rocco

Auto-generated profile, based on publicly available information

Emma Rocco

U.S. Naval Research Laboratory 1 , Washington, District of Columbia 20375

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 August 2020 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
VMVincent E Meyers
Vincent E Meyers
ERE. Rocco
E. Rocco
TAT. J. Anderson
T. J. Anderson
JGJ. C. Gallagher
J. C. Gallagher
MEM. A. Ebrish
M. A. Ebrish
FSF. Shahedipour-Sandvik
F. Shahedipour-Sandvik
We demonstrate p-type activation of GaN doped by Mg ion implantation, and in situ during metalorganic chemical vapor deposition through sequential short-duration gyrotron microwave heating cycles at temperatures of 1200–1350 °C. GaN is implanted with 1019 cm−3 Mg ions, capped with AlN, and annealed under 3 MPa N2 overpressure in 5 s heating cycles for less than 60 s total using a high-power gyrotron microwave heating source. Through I–V characterization, photoluminescence spectroscopy, and Raman spectroscopy, we study the evolution of electrical properties, optically active point defects, and material strain in response to implantation and annealing. For Mg-implanted samples, increasing annealing temperature is characterized by an increase in the PL substitutional Mg-related peak (UVL) relative to the shallow-donor vacancy-related peak (GL2). Through comparison of implanted and in situ doped samples, it is demonstrated that the origin of compensating VN lies primarily in implantation rather than degradation from the annealing process. Transmission line measurements and diode I–V measurements show a sheet resistance of 1083 kΩ/□ and a hole concentration of 1.23 × 1015 cm−3, respectively, in the Mg-implanted material annealed at 1350 °C. We conclude that temperature-cycled gyrotron annealing at 1350 °C decreases implant-induced compensating point defects and activates Mg to obtain selective p-type conduction.

17 September 2018 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
JMJonathan Marini
Jonathan Marini
IMIsra Mahaboob
Isra Mahaboob
EREmma Rocco
Emma Rocco
LBL. D. Bell
L. D. Bell
FSF. Shahedipour-Sandvik
F. Shahedipour-Sandvik
We report on holistic and systemic approach of development of Cs-free GaN photocathode structures which utilize polarization band engineering in order to allow for air stable operation and eliminate the need for cesium-based surface treatments. Physics-based simulation of band structure and Monte Carlo simulation of electron transport and emission were used to guide experimental development of photocathode structures. By using an N-polar device, the polarization charge allows for the creation of large surface band bending without the need for δ-doped capping layers. The insertion of a thin AlN interlayer allows for the creation of a quasi-band offset and additional beneficial polarization charge to create a desirable band profile. Samples of both polarities were grown and subjected to chemical surface treatments in order to account for differences in native oxide formation on Ga- and N-polar surfaces. Measured photoemission spectra show quantum efficiencies as high as 23% for a HCl-treated Cs-free N-polar photocathode, which is comparable to cesiated devices.

29 January 2020 in Scientific Reports
Verified
Journal Article
Open access
PDF file
EREmma Rocco
Emma Rocco
OLOlivia Licata
Olivia Licata
IMIsra Mahaboob
Isra Mahaboob
KHKasey Hogan
Kasey Hogan
STSean Tozier
Sean Tozier
FSF. Shahedipour-Sandvik
F. Shahedipour-Sandvik
We report on the enhanced incorporation efficiency of magnesium dopants into facets of hexagonal hillock structures in N-polar GaN, studied by comparative analysis of GaN:Mg films grown by MOCVD on high and low hillock density GaN template layers. Total magnesium concentration in planar regions surrounding a hillock structure is comparable to that within hillock sidewall facets measured at 1.3 × 1019 cm−3 by atom probe tomography, and clustering of Mg atoms is seen in all regions of the film. Within individual hillock structures a decreased Mg cluster density is observed within hillock structures as opposed to the planar regions surrounding a hillock. Additionally, the Mg cluster radius is decreased within the hillock sidewall. The favorable incorporation of Mg is attributed to Mg dopants incorporating substitutionally for Ga during growth of semi-polar facets of the hillock structures. Enhanced p-type conductivity of GaN:Mg films grown on high hillock density template layers is verified by optical and electrical measurement.

6 May 2019 in IEEE Journal of the Electron Devices Society
Verified
Journal Article
Open access
IMIsra Mahaboob
Isra Mahaboob
MYMichael Yakimov
Michael Yakimov
KHKasey Hogan
Kasey Hogan
EREmma Rocco
Emma Rocco
STSean Tozier
Sean Tozier
FSF. Shahedipour-Sandvik
F. Shahedipour-Sandvik
We report on the implementation of dynamic body-bias technique to improve the performance of AlGaN/GaN high electron mobility transistors (HEMTs) with the successful integration of body-diode. In this configuration, p-GaN body-diode based back-gate control is used to shift the threshold voltage and dynamically modulate the ON/OFF characteristics of a normally-ON AlGaN/GaN HEMT. A fourth back-gate terminal is connected to the p-GaN layer to control the depletion width of the body-diode, which in turn modulates the 2DEG density. A positive/negative shift in the threshold voltage is measured by increasing/decreasing the depletion width below the channel. A positive back-gate bias application in the ON-state is shown to increase the 2DEG current density resulting in higher ON-current. The application of a negative back-gate bias is shown to be effective in the positive shift of the threshold voltage, in reducing the 2DEG channel current and in increasing the OFF-state break-down voltage. We have experimentally demonstrated enhanced effect of body-diode based back-gate control in shifting the threshold voltage of a normally-ON HEMT towards normally-OFF mode. The optimum back-gate voltage range which can be applied during both ON and OFF states has been experimentally determined.

19 July 2021 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
OLOlivia G. Licata
Olivia G. Licata
SBScott Broderick
Scott Broderick
EREmma Rocco
Emma Rocco
FSFatemeh Shahedipour-Sandvik
Fatemeh Shahedipour-Sandvik
BMBaishakhi Mazumder
Baishakhi Mazumder
In this work, an in-depth analysis of atomic level dopant-defect interactions in N-polar GaN:Mg was performed using atom probe tomography (APT). The 3D visualization of ion distribution revealed the formation of spherical Mg-rich clusters and the segregation of Mg dopant toward dislocations in MOCVD-grown GaN:Mg. Impurities, such as oxygen and hydrogen, were identified and detected adjacent to Mg-rich dislocations. Crystal stoichiometry around the defect regions was investigated to understand how the defects can influence dopant diffusion. Non-stoichiometric regions of N:Ga were found adjacent to Mg-rich dislocations and overlapping with some Mg-rich clusters, indicating dopant-defect interplay. Variations in N:Ga were not proportional to the Mg content, suggesting that the micro-features (clusters and dislocations) interact differently with local chemistry. Techniques for defining the quality of an APT experiment through invalidation of artifacts are also demonstrated. Mg-rich defects and variations in N:Ga were found to be independent of artifacts related to the evaporation field in APT.

13 August 2018 in Journal of Electronic Materials
Verified
Journal Article
Closed access
PDF file
IMIsra Mahaboob
Isra Mahaboob
JMJonathan Marini
Jonathan Marini
KHKasey Hogan
Kasey Hogan
EREmma Rocco
Emma Rocco
RTRandy P. Tompkins
Randy P. Tompkins
FSFatemeh Shahedipour-Sandvik
Fatemeh Shahedipour-Sandvik