9 September 2020 in Nature
22 January 2019 in IEEE Electron Device Letters
We report the first demonstration of fully-vertical power MOSFETs on 6.6-μm-thick GaN grown on a 6-inch Si substrate by metal-organic chemical vapor deposition (MOCVD). A robust fabrication method was developed based on a selective and local removal of the Si substrate as well as the resistive GaN buffer layers, followed by a conformal deposition of a 35-μm-thick copper layer on the backside by electroplating, which provides excellent mechanical stability and electrical contact to the drain terminal. The fabrication process of the gate trench was optimized, improving considerably the effective mobility at the p-GaN channel and the output current of the devices. High performance fully-vertical GaN-on-Si MOSFETs are presented, with low specific on-resistance (Ron,sp) of 5 mΩcm2 and high off-state breakdown voltage (BV) of 520 V. Our results reveal a major step towards the realization of high performance GaN vertical power devices on cost-effective Si substrates.
27 April 2020 in IEEE Transactions on Power Electronics
1 November 2016 in Thin Solid Films
25 November 2021 in IEEE Transactions on Power Electronics
For certain field-effect transistors (FETs) in soft-switching operation, the large-signal behavior of their output capacitance ( ${C}_\text{o}$ ) has shown to deviate considerably from the datasheet values. This can have a significant effect on hard-switching losses if the value of output charge is also different for a given voltage. In addition, standard hard-switching tests are incapable of fully setting apart the contributions from ${C}_\text{o}$ , whereas existing methods tailored to characterize ${C}_\text{o}$ losses in soft-switching operations subject ${C}_\text{o}$ to a fundamentally different charge–discharge process, and hence, might not predict the correct behavior for hard switching. To address this, first, we analyze and establish the particular charge–discharge conditions that ${C}_\text{o}$ undergoes in hard-switching circuits by considering a half bridge at no-load conditions. We show that the channel of the switching device incurs a fixed energy loss during the turn- on process, which is separated into co-energy and stored energy components of the top (complementary) and bottom (switching) devices, respectively. Exploiting this, a new measurement technique is developed to obtain output-charge versus voltage curves of devices subjected to actual hard switching. The experimental results for commercial Si, SiC, and GaN devices indicate that the effective charge-capacity of ${C}_\text{o}$ for hard switching can considerably vary from the values based on datasheets or Sawyer–Tower circuit; this could greatly undermine efficiency and thermal optimizations in the design phase of power converters.
28 October 2019 in Journal of Applied Physics
Many high power (opto-) electronic devices such as transistors, diodes, and lasers suffer from significant hot spot temperature rises due to the high heat fluxes generated in their active area, which limits their performance, reliability, and lifetime. Employing high thermal conductivity materials near the heat source, known as near-junction heat spreaders, offers a low-cost and effective thermal management approach. Here, we present analytical heat spreader models and a methodology to evaluate their performance. Experimental demonstration of near-junction diamond heat spreaders on vertical GaN PiN diodes revealed significantly reduced spreading resistances, along with very low temperature gradients across the device. The findings in this work provide design guidelines and demonstrate excellent prospects, especially for the devices on low thermal conductivity substrates. The theoretical analysis of optimized diamond heat spreaders shows an 86% reduction of spreading resistance for GaN devices and 98% for Ga2O3 devices. In addition, our results show that a 3 μm-thick layer of high-quality CVD-deposited diamond heat spreaders on GaN-on-Si devices can provide better heat spreading than GaN-on-SiC devices and perform similar to GaN-on-diamond devices, highlighting the significant potential of heat spreaders as an effective and low-cost thermal management approach.