29 August 2018 in IEEE Transactions on Vehicular Technology
In this paper, we consider a cell-free massive MIMO system where many access points (APs) serve a much smaller number of users under the time-division duplex operation. The APs first estimate the channels via the uplink training phase. Then these channel estimates are used to detect desired symbols in the uplink and precode the transmit symbols in the downlink. Non-orthogonality of pilot sequences and AP selection are taken into account. To reduce the effect of pilot contamination, we propose a pilot power control design which chooses the pilot power control coefficients to minimize the mean-squared error of the channel estimation. This can be done by using the sequential convex approximation method. By using pilot power control in training phase, the system performance is considerably improved. In addition, we derive closed-form expressions for the uplink and downlink achievable rates with arbitrary power data/pilot control coefficients and any AP selection schemes.
28 April 2020 in IEEE Transactions on Communications
12 February 2021 in IEEE Transactions on Communications
Cell-free massive multiple-input multiple-output (MIMO) system is a promising architecture for next generation wireless systems by deploying a very large number of distributed access points (APs), which simultaneously serve a smaller number of user equipments (UEs) over the same time-frequency resources. It guarantees uniformly good service at high spectral efficiency with simple linear precoding techniques and max-min power control. In this article, we propose a new joint maximum-ratio and zero-forcing (JMRZF) precoding scheme, where part of APs are combined to perform centralized zero-forcing (ZF), while other APs apply simple maximum-ratio transmission (MRT). Our proposed precoder offers an adaptable trade-off between the spectral efficiency and front-haul signalling overhead. A corresponding AP subset selection scheme is also proposed which is based on large-scale fading coefficients. A closed-form expression for the achievable spectral efficiency of our proposed scheme is derived, which represents a generalized result including both fully distributed MRT and fully centralized ZF cases. Based on this closed-form expression, max-min power control is formulated and solved via the second order cone and first order methods. The former can obtain the global optimal solution, but its computational complexity is very high. On the other hand, the latter technique is sub-optimal, yet, it has very low computational complexity. Hence, it is suitable for large-scale cell-free massive MIMO systems with hundreds or thousands of APs and users. Numerical results show that our proposed JMRZF scheme can substantially outperform the local precoding schemes, even when a small part of APs are combined to deploy ZF and is implementable even when each AP has very few antennas. In addition, it is shown that our max-min power controls improves the spectral efficiency significantly, compared to the uniform power control scheme.
9 February 2022 in IEEE Transactions on Wireless Communications
This paper considers the fundamental power allocation problem in cell-free massive mutiple-input and multiple-output (MIMO) systems which aims at maximizing the total energy efficiency (EE) under a sum power constraint at each access point (AP) and a quality-of-service (QoS) constraint at each user. Existing solutions for this optimization problem are based on solving a sequence of second-order cone programs (SOCPs), whose computational complexity scales dramatically with the network size. Therefore, they are not implementable for practical large-scale cell-free massive MIMO systems. To tackle this issue, we propose an iterative power control algorithm based on the frame work of an accelerated projected gradient (APG) method. In particular, each iteration of the proposed method is done by simple closed-form expressions, where a penalty method is applied to bring constraints into the objective in the form of penalty functions. Finally, the convergence of the proposed algorithm is analytically proved and numerically compared to the known solution based on SOCP. Simulations results demonstrate that our proposed power control algorithm can achieve the same EE as the existing SOCPs-based method, but more importantly, its run time is much lower (one to two orders of magnitude reduction in run time, compared to the SOCPs-based approaches).
15 February 2017 in IEEE Communications Letters
A key problem in nanomachine networks is how information from sensors is to be transmitted to a fusion center. In this letter, we propose a molecular communication-based event detection network. In particular, we develop a detection framework that can cope with scenarios where the molecules propagate according to anomalous diffusion instead of the conventional Brownian motion. We propose an algorithm for optimizing the network throughput by exploiting tools from reinforcement learning. Our algorithms are evaluated with the aid of numerical simulations, which demonstrate the trade-offs between the performance and complexity.