In this letter, a single-layer compact copolarized shorted TM 1/2,0 mode microstrip patch antenna is presented for in-band full-duplex application. Two shorted TM 1/2,0 mode patch antennas, used for transmission and reception purposes, make the structure compact. The wideband behavior of the patch antenna is obtained by fusing the two resonances, one because of the shorted TM 1/2,0 mode radiating patch and the other because of the λ/4 line resonator. To enhance the isolation between the transmitter and receiver antenna, a novel defected ground structure is used. Slots are introduced into the ground plane to create a weak field region for the basic antenna element. The other antenna element (receiver) is located in the weak field region to enhance isolation. Further enhancement in isolation is achieved by introducing a T-shaped metallic strip into the slots. The structure is proposed with the credits of compactness, enhanced bandwidth, colinear polarization, very less fabrication complexity, low profile, and high isolation. The proposed structure is fabricated and measured. The structure experimentally exhibits a bandwidth (≤ −10 dB) of 2.42–2.52 GHz with the isolation of 25 dB, peak isolation of 36 dB, and an average realized gain of 4 dBi in the entire band.
This article presents a linear microstrip patch antenna array at the X-band that incorporates an aperiodic artificial magnetic conductor (AMC) metasurface which utilizes phase cancellation techniques for reducing both the in-band and out-of-band Radar Cross Section (RCS). The structure consists of two substrates with three layers, the top layer consists of 8 antenna elements along with AMCs which are aperiodically oriented for wideband RCS reduction, and the middle layer (in between the two substrates) consists of a corporate feed network for the antenna array, followed by the ground plane in the bottom layer. Few AMC blocks have been used to achieve a wideband RCS reduction in the frequency range of 6 GHz to 16 GHz with more than 85% reduction in both X- and Y-polarizations utilizing a low profile, compact design. Along with the monostatic RCS reduction, a bistatic RCS reduction up to 40° has also been observed in simulations. The proposed structure has been fabricated and measurements of the reflection coefficient, gain, patterns, and monostatic RCS plots have been carried out. Measured results indicate good agreement with the results of the simulations after considering all measurement errors.
An eight-element wideband multiple-input multiple-output (MIMO) antenna for the fifth-generation (5G) mobile terminal is proposed. The antenna elements are placed along both long side edges of the mobile terminal with a profile of 6 mm. The proposed monopole-inspired antenna element shows a good impedance match, isolation, and diversity parameter across a very wide bandwidth of 78 % (3.2-7.3 GHz), and it can cover the 5G NR n77/n78/n79/n96, LTE 46, and WLAN 5 GHz bands. The result shows that the MIMO antenna can offer inter-element isolation better than 12 dB, envelope correlation coefficient (ECC) below 0.069, and a peak channel capacity of 42.7 bps/Hz across the desired 5G bands. The specific absorption rate (SAR) analysis of the proposed MIMO antenna with a human head has exhibited SAR levels (0.41 W/Kg and 0.33 W/Kg at two resonating frequencies 3.9 GHz and 5.8 GHz, respectively) much lower than the Federal Communications Commission (FCC) permissible limit (1.6 W/Kg over 1 gram tissue).
9 September 2021 in Journal of Electromagnetic Waves and Applications
A compact five-port multi-input multi-output (MIMO) antenna for n79 (4.4–5 GHz) 5G band exhibiting pattern and polarization diversity with good isolation is proposed in this paper. This MIMO antenna system comprises of four linearly polarized (LP) endfire monopole antenna elements and one broadside L-shaped slot circularly polarized (CP) antenna element, which provides both pattern and polarization diversity. A T-shaped slot as a decoupling structure is further used to improve the interport isolation by 4 dB. The return loss bandwidth for all antenna elements is in the desired frequency range, and antenna elements provide isolation better than 23 dB. The pattern and polarization diversity provide a low envelope correlation coefficient and good isolation between any two-port of the MIMO antenna. For experimental verification, the proposed 5-port MIMO antenna system is fabricated and measured, which provides decent agreement with the simulated performance.
15 June 2023 in IEEE Antennas and Wireless Propagation Letters
A two-stage beam-forming technique for a wide tilt angle is proposed in this letter. The proposed structure has the potential to overcome the limitations of Butler matrix-based beam-forming technique and reconfigurable FSS-based beam-forming technique, both of which normally lag behind in the present generation of wireless communication due to lesser number of radiating beams. The composite system comprises three parts: a 4 × 4 Butler matrix, an antenna array of 1 × 4 elements, and a reconfigurable FSS layer. Four semi-rigid coaxial cables are employed to connect the Butler matrix to the four-element antenna array. The reconfigurable FSS is mounted on top of antenna layer using air spacers. The FSS superstrate layer consists of 6 × 6 reconfigurable unit cells, which have been further divided into two equal sections to increase the number of radiating beams. Combining the four-port Butler matrix with reconfigurable FSS allows the system to generate twelve unique radiating beams in twelve distinct directions in three-dimensional space. The proposed system is designed, fabricated, and measured for operating frequency of 5.5 GHz. The proposed system attains a maximum tilt of 72° and peak gain of 11.8 dBi.
30 March 2021 in Microwave and Optical Technology Letters