Black carbon is the second largest contributor to climate change and also poses risks to human health. Despite the need for black carbon (BC) emissions estimates from residential biomass burning for cooking, quantitative data are still scarce. This scarcity is mainly due to the scattered location of the stoves, as well as relatively costly and complex analytical methods available. Two low cost and easy-to-use optical methods, a cell-phone based system and smoke stain reflectometry, where compared to elemental carbon (EC) concentrations by the Sunset OCEC Analyzer (TOT). The three techniques were challenged with different aerosol types (urban and biomass cookstoves), and different filter substrates (quartz and glass fibre). A good agreement was observed between the two low cost techniques and the reference system for the aerosol types and concentrations assessed, although the relationship was statistically different for each type of aerosol. The quantification of correction factors with respect to the reference method for the specific conditions under study is essential with either of the low-cost techniques. BC measurements from the cell-phone system and the reflectometer were moderately affected by the filter substrate. The easy use of the cell-phone based system may allow engaging cookstove users in the data collection process, increasing the amount and frequency of data collection which may, otherwise, not be feasible in resourced constrained locations. This would help to raise public awareness about environmental and health issues related to cookstoves.
31 October 2020 in Journal of Material Cycles and Waste Management
This paper identifies and analyses early degradation mechanisms observed in photovoltaic (PV) modules of power plants over 7 years of operation on the coast power grid in Mauritania. Performance degradation takes place due to several reasons such as material degradation following dust accumulation, high temperature, and humidity. Also, mismatch of electric power parameters such as increasing loads above projected values of the plant. Therefore, this paper analyses and studies the degradation in four phases. First, the visual inspection detects the degradation of materials and defects such as the presence of dust, cracks, browning (discoloration), and connection corrosion. The second phase proposes a mathematical model to calculate the early degradation rate (DR) of different components, such as short circuit current (Isc), open circuit voltage (VOC), the maximum yield power (Pmax), and the fill factor (FF) of the PV module. The third phase is a MATLAB modeling of the measured real-time data of the operating PV system to test Power versus voltage curves (with and without degradation) to examine the presence of failure of PV modules. Finally, compare the evolution of real-time production data for three measured years (2015, 2016, and 2017) with the simulation curves of this study.
A new approach for sizing a hybrid solar-PV-battery and biogas generator for power generation was suggested in this study, based on the variation of energy resources and the load profile. Biogas has enormous potential and numerous economic and social advantages. In this respect, the monthly solar radiation, temperature, and biogas produced from biomass resources were used as model inputs. This study considers the total annualized of the components for the feasibility analysis. HOMER Pro® software-based outcomes in the proposed methodology revealed that the proposed solar biogas hybrid system was sufficient to meet the load requirements of the village (Ain Farba village in the Hodh El Gharbi area located in the northeast of the Mauritania country) with a net present cost over the 25-year lifespan of 61,144 $ and the energy cost was determined to be 0.0473 $/kWh.