9 August 2019 in IEEE Transactions on Microwave Theory and Techniques
Wideband and low-noise tunable oscillators at microwave frequencies are crucial within microwave frequency synthesizers and key to high-end measurement systems based on electromagnetic sensing in the microwave range as well as in the terahertz (THz) and sub-THz range. This paper presents a novel, wideband, and low-noise differential yttrium iron garnet (YIG) tuned oscillator. It is based on a SiGe monolithic microwave integrated circuit and a transmission-type YIG resonator. The integrated circuit contains a fully differential amplifier as a part of the oscillator core. The resonator was realized by two orthogonal, crossed pad-to-pad bonds and an YIG sphere, which is positioned between those bonds and the integrated circuit. To design and optimize the oscillator, an equivalent circuit modeling the resonator was developed. Concerning the tuning range and the phase noise, the results of the circuit simulations are in good agreement with the measurements. Two oscillators with different lengths of the inductive load transmission line were realized. First, the oscillator with a short transmission line offers very high-oscillation frequencies with a tuning range from 32.0 to 48.2 GHz. It exhibits an excellent phase noise of less than -119,dBc/Hz at an offset frequency of 100,kHz for oscillation frequencies up to 42,GHz. Second, the oscillator with a longer transmission line length offers a tuning range from 19.1 to 41.4 GHz. This configuration exhibits an excellent phase noise of less than -120,dBc/Hz at an offset frequency of 100 kHz for oscillation frequencies up to 38,GHz.
25 November 2024 in IEEE Transactions on Terahertz Science and Technology
This work presents a comprehensive analysis of indium phosphide (InP) triple-barrier resonant tunneling diodes (TB-RTDs) operating as direct terahertz (THz) detectors at zero bias. Through analytical derivation, the influence of device dimensions and of current-voltage curvature on voltage responsivity and noise equivalent power (NEP) is explored, and theoretical expressions for diode sensitivity are derived. On-wafer measurements of two scaled TB-RTDs with top contact areas of 0.5 ${\mu }\mathrm{m}^{2}$ and 1 ${\mu }\mathrm{m}^{2}$ are conducted, followed by a comparative analysis, including harmonic-balance simulation results based on a self-developed TB-RTD nonlinear model. The measurements reveal that the responsivity scales with device area, as predicted by the theory, with a peak responsivity of 2123V/W at 340GHz for the TB-RTD, and above 1200V/W across the entire WR2 band (330–500GHz) for the smaller 0.5 ${\mu }\mathrm{m}^{2}$ area device. The NEP values do not exceed 3.5 $\mathrm{pW}/{\sqrt\mathrm{{Hz}}}$ and ${2}\mathrm{pW/{\sqrt{\rm{Hz}}}}$ for the 1 ${\mu }\mathrm{m}^{2}$ and 0.5 ${\mu }\mathrm{m}^{2}$ devices, respectively, with the lowest measured NEP being ${1.15}\mathrm{pW/{\sqrt{\rm{Hz}}}}$ for the 0.5 ${\mu }\mathrm{m}^{2}$ device. These sensitivity values place the TB-RTD at a level comparable with the state-of-the-art THz direct detectors operating at room temperature. The investigation offers a clear picture of the intrinsic performance of TB-RTD operating at zero bias, with a detailed overview of the on-wafer measurement setup, power characterization method, and detector figures of merit, highlighting the potential of TB-RTDs as compact, power-efficient, and ultra-sensitive direct THz detectors.
27 July 2018 in IEEE Transactions on Microwave Theory and Techniques
Phase-locked loops (PLLs) for ultra-wideband, low noise, and linear frequency ramp synthesis exhibit a wide variation of the loop gain, if no compensation method is applied. This impairs the performance of the PLL and the corresponding microwave measurement systems. To overcome the disadvantages of existing compensation techniques, we present a new compensation method based on a phase-frequency detector gain modulation. This offers low hardware complexity and avoids additional noise. Furthermore, we present an ultra-wideband, low noise monolithic microwave-integrated circuit for 60-GHz PLLs. Based on this, a 60-GHz frequency synthesizer with a modulation bandwidth of 22 GHz and a jitter of less than 79 fs at the center frequency are realized. The new compensation technique reduces the variation of the loop gain from 14.2:1 to 1.67:1 and is compared with an existing compensation technique utilizing a voltage-dependent damping network, which reduces the variation of the loop gain to 1.78:1. Due to the reduction of the variation of the loop gain, the maximum ramp slope increases from 22 GHz/2.9 ms up to 22 GHz/0.35 ms. In addition, the time jitter of the output signal of the PLL decreases by up to 18%. Furthermore, the PLL performance is constant in the temperature range from 0 °C to 70 °C.
17 July 2023 in IEEE Transactions on Radar Systems
During the production of fiber composites, individual layers can be displaced, which can drastically influence the load-bearing capacity of the object to be manufactured. Existing systems in the field of non-destructive testing of fiber composites are either impractical to use in everyday production or do not offer the possibility of examining the structure of the individual fiber layers. For this reason, we present a novel sensor concept that can detect typical defects caused during manufacturing. The concept is based on a millimeter wave SAR approach using a fully polarimetric FMCW radar sensor working at a center frequency of 60.5 GHz, with 17GHz bandwidth. The sensor offers a phase noise of -77 dBc/Hz at 1MHz offset from the carrier, with chirp times of 1 ms over the whole bandwidth, while maintaining a RMS frequency deviation of 1.24 ppm. Using a polarimetric decomposition scheme, we can detect the displacement of individual fiber layers, although the thickness of the layers is below the theoretically achievable range resolution of the radar.
27 January 2023 in International Journal of Microwave and Wireless Technologies
Radio telescopes are among the applications with the highest demands on a local oscillator (LO), which is used to receive and process the signals coming from the sky. Therefore the modules providing the required LO signal have traditionally been big and complicated. To overcome this disadvantage, we implement our own integrated frequency synthesizer inside a small LO module in this article. With this synthesizer we are able to achieve a jitter of only 50 fs integrated from 10 Hz to 2.5 GHz offset at a carrier frequency of 75 GHz. This is in part achieved by a very low in-band phase noise of −111.8 dBc at 10 kHz offset. The stabilizable frequency range is 62–88 GHz. Thus achieving promising results to fulfill this very demanding task with integrated frequency synthesizers in the future.
23 November 2022 in IEEE Transactions on Wireless Communications
Recent studies have shown that intelligent reflecting surfaces (IRS) can significantly improve the spectral and energy efficiency of wireless communication links. However, most works assume perfect transceivers and IRS, which is impractical in real communication systems. In this work, we study the effect of the hardware impairments in IRS-assisted MISO systems with single user, where we consider both phase noise caused by the imperfect transceivers and IRS. To this end, we propose a linear minimum mean square error (LMMSE) channel estimation algorithm that takes the phase noise into account. Furthermore, we study the impact of phase noise on the downlink performance of an IRS-assisted system. Both analytical and numerical results are presented, where we prove that the transceiver phase noise can be compensated with the optimized IRS, while the IRS phase noise remains but is not exacerbated. As the number of reflective elements N approaches infinity, the IRS phase noise results in a constant loss in terms of the ergodic rate. Moreover, we find that the phase noise has no impact on the scaling laws. If the direct channel is blocked and as N → ∞, the transmit power can be scaled down by 1/ N and 1/ N 2 , respectively, for random and optimized IRS, without compromising the received signal to noise ratio (SNR).