We present a broadband free space light communication system using high-speed organic light emitting diodes (OLEDs) as transmitters. Firstly, we report the design and bandwidth measurements of micro-OLEDs with active area of 40x40μm². For this OLED, a cut-off frequency up to 459 MHz is observed. Secondly, by applying Direct Current Optical Orthogonal Frequency Division Multiplexing (DCO-OFDM) with adaptive bit and energy loading techniques, a data rate of 2.85 Gb/s is achieved. The increase of bandwidth and throughput reported in the current work are attributed to the improvements at the material, device and transmission levels. At the material level, a low work function Calcium cathode and ALD encapsulation of OLED is considered. At the device level, the active area is reduced in size and the OLEDs thickness is optimized. At the transmission level, parameters such as bias voltage, modulation amplitude and clipping have been fine-tuned to obtain high data rate.
In this letter, Gallium Nitride (GaN) blue micro-Light-Emitting-Diodes ( $\mu $ LEDs) reported on a 200-mm Silicon substrate are utilized for multi-Gb/s data transmission. The manufacturing process is compatible with CMOS integrated circuit design, paving the way for fully integrated transmitters for $\mu $ LED-based visible light communications (VLC) or chip-to-chip interconnects. Fiber-guided transmission has been realized using direct current optical-orthogonal frequency division multiplexing (DCO-OFDM) modulation, and a data rate of 5.9 Gb/s at a Bit-Error-Rate (BER) of $3.8\times 10 ^{-3}$ is reported using a single $50 \times 50~\mu $ m2 blue $\mu $ LED. This data rate was further improved to reach 15.5 Gb/s in the case where the $\mu $ LED is only limited by its non-linear distortions instead of the system’s noise, highlighting the high linearity of GaN $\mu $ LEDs.
6 February 2026 in Journal of Lightwave Technology
High-speed micro light-emitting diodes (LEDs) are attractive candidates for optical communications (OC) due to their wide bandwidth and energy efficiency. However, their strong nonlinear distortion severely degrades system performance. In this work, we present the first adaptation of the generalized memory polynomial model to micro-LED-based OC and propose a second approach based on a novel pruned Volterra model. Training and validation of the models are performed using digital postdistortion. Experimental validation on gallium nitride micro-LEDs driven by direct current-biased optical orthogonal frequency division multiplexing shows significant improvements, including a 71% throughput increase, from 4.32 Gb/s to 7.38 Gb/s. These results demonstrate the strong potential of these compensation schemes to unlock energy-efficient, high-speed micro-LED optical links.