Based on the results of temperature-dependent photoluminescence (PL) and absorption measurements, the PL emission in GaNP epilayers and GaNP/GaP multiple quantum well structures with N composition up to 4% is shown to be dominated by optical transitions within deep states likely related to N clusters. With increasing N composition, these states are shown to become resonant with conduction band of the alloy and thus optically inactive, leading to the apparent redshift of the PL maximum position.
Improvement of polyvinyl alcohol stability against ultraviolet (UV) illumination is achieved by introducing cadmium sulfide (CdS) nanoparticles into the polymeric matrix. Enhancement of stability is analyzed by optical characterization methods. UV protection is achieved by diminishing the probability of photo-activated formation of defects in polymer. The sources of polymer protection are the lowering of the efficiency of polymer excitation via partial absorption of incident light by the embedded nanoparticles as well as the de-excitation of the macromolecules that have already absorbed UV quanta via energy drain to nanoparticles. Within the nanoparticles, the energy is either dissipated by conversion to the thermal energy or reemitted as visible-range photoluminescence quanta.
The absorption edge of alloys is shown to exhibit a direct-band gap-like behavior. Thermal variation of the band gap energy however, is found to be the same or even smaller than that for the indirect band gap of GaP and depends on the N content. The effect is tentatively attributed to the following counteracting contributions to the band edge formation. An interaction with N-related localized states, especially significant in the vicinity of band crossover (e.g., causes a substantial slow down of the shift with temperature. On the contrary, an increasing contribution of states, which becomes predominant for the higher compositions, leads to the larger thermal variation in
Exciton spin relaxation in diluted magnetic semiconductor (DMS) structures based on ZnMnSe is closely examined as a function of exciton spin splitting in an external magnetic field. A drastic increase in spin relaxation is observed when exciton spin splitting exceeds the longitudinal optical (LO) phonon energy. Direct experimental evidence has been provided from (1) spin injection from the DMS to an adjacent nonmagnetic quantum well that can be modulated by the LO-assisted spin relaxation and (2) hot exciton photoluminescence within the DMS where a spin flip is accompanied by the emission of one LO phonon.
1 August 2015 in Journal of Colloid and Interface Science
The ability of attaining desired spin functionality by adjusting structural design is demonstrated in diluted magnetic semiconductor (DMS) quantum structures based on II–VI semiconductors. The following spin enabling functions are achieved by tuning the ratio between the rates of exciton spin relaxation within the DMS and exciton escape from it to an adjacent nonmagnetic spin detector. Spin switching is realized when using a thin layer of as a spin manipulator and is attributed to a fast exciton escape from the DMS preceding the spin relaxation. Spin alignment is accomplished in tunneling structures where the presence of an energy barrier inserted between a spin manipulator (a DMS-based superlattice) and a spin detector ensures a slow escape rate from the DMS layer.