This experimental study is focused on the mechanisms of thermal atomisation of a drop impacting onto a hot substrate. This phenomenon is characterised by the wetting and dewetting of the substrate, caused not by the rim dynamics, but induced by thermal effects. These thermal effects lead to the lamella evaporation, levitation and disintegration, generation of a vertical spray of fine droplets and consequently, drop breakup. A typical contact time of the drop before complete detachment is theoretically estimated. This estimation agrees very well with the experiments. It is shown that the Weber number, often used for describing splashing drops, is not a relevant parameter for thermal atomisation. Finally, a regime map is plotted, using a combination of the dimensionless contact time and the dimensionless heat flux at the substrate.
Outcomes from an isothermal drop impact onto a surface (rebound, deposition, or splash) are determined by the impact parameters, liquid material properties, substrate morphology, and wettability. Drop impact onto a hot surface can be accompanied by Marangoni effects, nucleate or film boiling, and evaporation. The main focus of this experimental study is the characterization of the hydrodynamic outcome of a single-drop impact onto a hot surface. Drop impact phenomena have been observed and characterized using a high-speed video system. The impact parameters of the drop and the surface temperature have been varied. The observations lead to a classification of impact outcomes into several regimes: evaporation, nucleate boiling, foaming, transitional boiling, and film boiling. The contact time of the impinging droplet on the surface has been measured, and a model for this time and for the heat flux from the substrate to the drop has been proposed for the nucleate boiling regime. Comparison of model predictions to existing literature data is good.
1 October 2017 in International Journal of Heat and Mass Transfer