Robert Costanzo

Robert Costanzo

Auto-generated profile, based on publicly available information

Robert Costanzo

Department of Electrical and Computer Engineering, University of Virginia, Charlottesville, VA, USA

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 July 2018 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
RCRobert Costanzo
Robert Costanzo
SBSteven M. Bowers
Steven M. Bowers
A transimpedance amplifier (TIA) for use in high-bandwidth balanced photoreceivers is designed and demonstrated. The circuit, based on the regulated cascode (RGC) TIA, utilizes the current reuse strategy to provide performance increase and additional benefits over the traditional RGC TIA. Implemented in a 65-nm general-purpose CMOS process, the current reuse RGC TIA achieves a transimpedance of 62 dBQ across a -3-dB bandwidth of 11 GHz while consuming 10 mW of dc power, with a unity-gain differential output buffer for driving 50-Ω loads consuming 56 mW. High sensitivity is achieved due to a low equivalent input noise of 30 pA/√Hz. The total active area of the TIA, including an active balun and unity gain output driver, is 0.08 mm 2 , and 0.25 mm 2 with pads.

15 April 2019 in IEEE Journal of Selected Topics in Quantum Electronics
Verified
Journal Article
Closed access
TTTa-Ching Tzu
Ta-Ching Tzu
KSKeye Sun
Keye Sun
RCRobert Costanzo
Robert Costanzo
DADaniel Ayoub
Daniel Ayoub
SBSteven M. Bowers
Steven M. Bowers
ABAndreas Beling
Andreas Beling
We report on arrayed germanium-on-silicon waveguide photodetectors for high-power analog applications utilizing the AIM Photonics silicon foundry. Photodetector arrays with two, four, and eight elements reach output powers of −0.4 dBm, 10 dBm, and 14.3 dBm at 18 GHz, 12 GHz, and 5 GHz, respectively. The 4-photodiode array has an output third order intercept point (OIP3) above 20 dBm up to 12 GHz and shows a 5-dB improvement over a single photodiode. An integrated 20 GHz receiver based on a pair of balanced photodiodes and a Mach–Zehnder delay line interferometer is successfully demonstrated in an optical phase-modulated link.

22 May 2020 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
RCRobert Costanzo
Robert Costanzo
SBSteven M. Bowers
Steven M. Bowers
A transimpedance amplifier (TIA) fabricated in a 55-nm low-power CMOS process is presented. The TIA, a current-reuse regulated cascode (CRRGC) topology, includes an active balun and differential output drivers. To maximize integration in high-speed photoreceivers, the TIA also includes dc current compensation, removing the requirement for bias-tees between the TIA and the photodiode (PD). The TIA achieves a transimpedance gain of 69 dBQ across a 3-dB bandwidth of 10.7 GHz. Additionally, the TIA demonstrates low-noise √ performance with an equivalent input noise density of 15 pA/ Hz in the passband. The dc compensation is capable of providing a fixed bias voltage for a PD while sourcing up to 2.4 mA or sinking up to 1 mA of photocurrent. The TIA, including active balun and dc current compensation, consumes 15.7 mW, while the output buffer consumes 90.7 mW. The total active area of the circuit is 0.07 mm 2 , and 0.21 mm 2 with pads.

5 January 2021 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
XSXiaochuan Shen
Xiaochuan Shen
JMJesse Morgan
Jesse Morgan
RCRobert Costanzo
Robert Costanzo
KSKeye Sun
Keye Sun
MWMadison Woodson
Madison Woodson
SBSteven M. Bowers
Steven M. Bowers
High-power V-band-to-G-band (50-220 GHz) photonically driven electromagnetic emitters, composed of frequency-independent (FI) antennas and charge-compensated modified unitraveling carrier photodiodes (CC-MUTC PDs), are demonstrated in this article. The designed and fabricated PDs achieve a responsivity of 0.2 A/W and are able to provide up to 12-dBm output power. The impedances of the PD and the FI antennas (the sinuous antenna, the spiral antenna, and the log-periodic antenna) are characterized, showing that different antennas could be selected to provide either highest radiated power or widest bandwidth depending on applications. The measurement results indicate that the integrated emitter with the sinuous antenna and the 8-μm PD achieves a record-high broadside effective isotropic radiated power (EIRP) of 20 dBm with an optical-to-terahertz (THz) power conversion efficiency of 15.7% while maintaining EIRP greater than 0 dBm up through 115 GHz of bandwidth (50-165 GHz). The emitter with the spiral antenna and the 5-μm PD provides a wide 3-dB bandwidth of 34 GHz with a maximum EIRP of 8.8 dBm. These high-power wideband emitters can be used for wireless communications, millimeter-wave (mm-wave) and sub-THz imaging, and radar systems.

9 September 2019 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
RCRobert Costanzo
Robert Costanzo
ZYZhanyu Yang
Zhanyu Yang
ABAndreas Beling
Andreas Beling
SBSteven M. Bowers
Steven M. Bowers
Two photoreceivers, each comprised of a set of InP balanced photodiodes (PDs) and one of two CMOS transimpedance amplifiers (TIA) fabricated in a 65 nm general-purpose process, are demonstrated in this paper. The balanced photodiodes achieve a responsivity of 0.65 A/W and a bandwidth of 12 GHz while driving a 50 Ω load. The first photoreceiver uses a 9 GHz bandwidth regulated cascode (RGC) TIA with 59 dBΩ transimpedance, achieving a maximum conversion gain of 1289 V/W and a minimum noise equivalent power (NEP) of 13 $\text{pW}/\root{\text{Hz}}$ . The second photoreceiver utilizes an 11 GHz bandwidth modified current-reuse regulated cascode (CRRGC) TIA with 63 dBΩ transimpedance gain, resulting in a maximum conversion gain of 2083 V/W and minimum NEP of 13 $\text{pW}/\sqrt{\text{Hz}}$ .

4 May 2021 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
RCRobert Costanzo
Robert Costanzo
JGJunyi Gao
Junyi Gao
XSXiaochuan Shen
Xiaochuan Shen
QYQianhuan Yu
Qianhuan Yu
AAAfnan Alabdulwahab
Afnan Alabdulwahab
SBSteven M. Bowers
Steven M. Bowers
A photoreceiver consisting of indium phosphide (InP) balanced photodiodes (PD) on Si 3 N 4 waveguides and a transimpedance amplifier (TIA) fabricated in a silicon germanium (SiGe) BiCMOS process is demonstrated. The InP PDs, heterogeneously integrated on a silicon substrate, achieve external (internal) responsivities of 0.75 (0.9) A/W, bandwidths of 4 GHz, and common mode rejection ratios (CMRR) of greater than 40 dB when illuminated differentially. The TIA achieves 74 dBΩ of transimpedance gain with a 1 dB peak, a bandwidth of 3 GHz, and a low equivalent input noise current density of 7.2 pA/√{Hz} when loaded with a C PD of 380 fF. The full photoreceiver achieves high conversion gain of more than 2 kV/W up through 2 GHz, and a low NEP of 8 pW/√{Hz} up through 1.6 GHz. The photoreceiver optical CMRR is measured to be 36 dB.