Silicon photonics is advancing rapidly in performance and capability with multiple fabrication facilities and foundries having advanced passive and active devices, including modulators, photodetectors, and lasers. Integration of photonics with electronics has been key to increasing the speed and aggregate bandwidth of silicon photonics based assemblies, with multiple approaches to achieving transceivers with capacities of 1.6 Tbps and higher. Progress in electronics has been rapid as well, with state-of-the-art chips including switches having many tens of billions of transistors. However, the electronic system performance is often limited by the input/output (I/O) and the power required to drive connections at a speed of tens of Gbps. Fortunately, the convergence of progress in silicon photonics and electronics means that co-packaged silicon photonics and electronics enable the continued progress of both fields and propel further innovation in both.
3 May 2019 in IEEE Journal of Solid-State Circuits
This paper presents the development of a wake-up receiver (WuRX) at nanowatt power levels for event-driven applications. This paper improves the state of the art, obtaining higher sensitivity than previous work in the 151.8- and 433-bands, low-power operation, and robustness to interference due to an integrated offset compensation algorithm operating without any external calibration. Simultaneous low-power operation and high sensitivity are achieved through a passive detector design based upon a terminal impedance boundary condition-based optimization of the detector dictated by the terminal impedances of the detector. This paper is implemented in a 130-nm CMOS process and obtains -76 dBm at the 151.8-MHz multi-use radio service (MURS) band and -71 dBm at the 433-MHz Industrial, Scientific and Medical (ISM) band with a total dc power draw of just 7.6 nW from 1.0- and 0.6-V supplies.
18 October 2022 in IEEE Open Journal of the Solid-State Circuits Society
Wake-up receivers (WuRXs) offer a potentially energy-efficient means to enable asynchronous wake-up of higher-power and higher-performance radios without needing frequent (often energy-expensive) synchronization. Since WuRXs are typically on for a large percentage of the time, keeping their power consumption very low is critical to minimizing total energy draw. However, this is difficult while maintaining good sensitivity, interference resiliency, and robustness, all with application-appropriate wake-up latencies and form factors. This article reviews the main challenges facing WuRXs, outlines the most popular WuRX architectures, and details essential design techniques and trade-offs towards enabling utility in emerging applications.
A transimpedance amplifier (TIA) for use in high-bandwidth balanced photoreceivers is designed and demonstrated. The circuit, based on the regulated cascode (RGC) TIA, utilizes the current reuse strategy to provide performance increase and additional benefits over the traditional RGC TIA. Implemented in a 65-nm general-purpose CMOS process, the current reuse RGC TIA achieves a transimpedance of 62 dBQ across a -3-dB bandwidth of 11 GHz while consuming 10 mW of dc power, with a unity-gain differential output buffer for driving 50-Ω loads consuming 56 mW. High sensitivity is achieved due to a low equivalent input noise of 30 pA/√Hz. The total active area of the TIA, including an active balun and unity gain output driver, is 0.08 mm 2 , and 0.25 mm 2 with pads.
12 February 2019 in IEEE Transactions on Microwave Theory and Techniques