The research on simultaneous synthesis of molybdenum carbides and of titanium carbides by sol–gel method was conducted. (NH4)6Mo7O24·4H2O and Ti[O(CH2)2CH3]4 were applied as precursors. The gaseous products were determined using mass spectrometry method. The phase composition of samples was identified by XRD method, and their morphology was examined by SEM method. After the hydrolysis of Ti[O(CH2)2CH3]4 nanometric TiO2 was received. Before the synthesis (NH4)6Mo7O24·4H2O decomposed into MoO3 (t ≤ 673 K). At the temperature of 689–943 K MoO3 was reduced into MoO2 (or also into Mo). The synthesis of Mo2C proceeded at the temperature of 973–1,189 K. In this temperature range also reduction of TiO2 into TixOy took place. The synthesis of titanium carbides proceeded at the temperature t ≥ 1,285 K.
22 December 2013 in Journal of Thermal Analysis and Calorimetry
Nanometric carbides of transition metals and silicon are obtained by using precursors. Control of the course of these processes require data concerning transformations of single precursor, transformations of precursor in the presence of reducing agent and synthesis of the carbide. In this work, the way of investigating such processes is described on the example of thermal decomposition of (NH4)6Mo7O24·4H2O (precursor) in argon. The measurements were carried out by TG–DSC method. The solid products were identified by XRD method, and the gaseous products were determined by mass spectrometry method. There was demonstrated that the investigated process proceeded in five stages. Kinetic models (forms of f(α) and g(α) function) most consistent with experimental data and coefficients of Arrhenius equation A and E were determined for the stages. The Kissinger method and the Coats–Redfern equation were applied. In case of the Coats–Redfern equation, the calculations were performed by analogue method. In this way good consistency between the calculated and determined conversion degrees α(T) at practically constant values of A and E were obtained for distinguished stages and different sample heating rates.
7 June 2013 in Journal of Thermal Analysis and Calorimetry
The results of investigation on influence of the milling process on mixed powders of nanocrystalline TiC and TiB2, obtained in non-hydrolytical sol–gel synthesis, and 316L stainless steel are presented. The powders have been used as substrates to prepare nanocomposite materials by Selective Laser Sintering/Melting process. In present work thermal analysis results along with the composition and structure of nanocrystalline powders have been presented. During investigation the following analytical techniques have been applied: XRD, TEM, TG-DSC-MS and SEM.
In this work, the results of investigations of manufacturing ceramic materials on the basis of Ti, B, C and N containing systems are presented. The nanocrystalline ceramics were synthesized using a non-hydrolytic sol-gel method. The process was carried out in two stages. In the first low-temperature stage the precursor was obtained. The synthesis of ceramic phases, however, was conducted in the second high-temperature stage, in an argon atmosphere. Depending on the initial composition of the mixtures, the temperature and the time, the following products were obtained: TiCx, TiCxN1−x, TiB2 and B4C. The course of the process was investigated by thermogravimetric and differential scanning calorimetry methods (TG-DSC) coupled with mass spectrometry (MS). The solid state products were identified with use of X-ray diffraction (XRD). The size of the crystallites was estimated by the Scherrer method. The structure and morphology images of nanocrystalline powders were obtained using scanning electron microscopy (SEM) and transmission electron microscopy (TEM).