T. Haber

T. Haber

Auto-generated profile, based on publicly available information

T. Haber

Institute of Solid State Physics, Graz University of Technology, Petersgasse 16, A-8010 Graz, Austria

Research Focus & Metrics

Academic Career Length

23Years (2004-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2004 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
JIJ. Ivanco
J. Ivanco
JKJoachim R. Krenn
Joachim R. Krenn
MRM. G. Ramsey
M. G. Ramsey
FNF. P. Netzer
F. P. Netzer
THT. Haber
T. Haber
GJG. Jakopic
G. Jakopic
The growth and the electronic properties of sexithiophene thin films on silicon surfaces have been studied by angle resolved ultraviolet photoelectron spectroscopy while morphology and crystalline order have been assessed by atomic force microscopy and x-ray diffraction. The influence of the surface modification of the substrate as well as of the growth temperature and the growth rate were investigated in ultrahigh vacuum through controlled multistep growth sequences ranging from (sub)monolayer coverage up to thick films. Depending on the preparation, two electronically distinct sexithiophene (6T) films could be produced, as revealed by their ionization potentials which differed by ∼0.7eV . The evolution of the electronic energy levels with film thickness is considered in terms of the concepts of interface dipole and band bending, with the latter being argued to be inappropriate. Irrespective of substrate or growth conditions the thick 6T films were found to all have the same work function of ∼0.4eV , which is related to near vertically oriented molecules on the films surface. Against general expectations 6T grown at a low rate on the reactive Si(111) substrate and those grown at high rates on the oxide surface produces films that are more uniform and crystalline than those grown at low rates on the passive oxidized Si surfaces. The latter promotes the formation of small three-dimensional crystallites and a much poorer morphology for planar devices.

7 September 2005 in Journal of Crystal Growth
Verified
Journal Article
Closed access
THT. Haber
T. Haber
AAA. Andreev
A. Andreev
ATA. Thierry
A. Thierry
HSH. Sitter
H. Sitter
MOM. Oehzelt
M. Oehzelt
RRRoland Resel
Roland Resel

18 July 2006 in Physical Review B
Verified
Journal Article
Closed access
PDF file
THT. Haber
T. Haber
SMS. Muellegger
S. Muellegger
AWA. Winkler
A. Winkler
RRRoland Resel
Roland Resel
We focus on the epitaxial growth of para-sexiphenyl on a Au(111) single-crystal surface. The films are prepared by molecular beam epitaxy at different temperatures (300K, 330K, and 430K), and their thicknesses are 30nm. X-ray diffraction investigations of these films show that the growth is strongly dependent on the substrate temperature. Lying molecules are always observed and lead to sexiphenyl crystals with their ±(21−3) plane parallel to the surface which corresponds to flat-on molecules with respect to the substrate. The in-plane alignment of the crystallites is determined by pole figure measurements, at which it is shown that it varies with the growth temperature. While standing molecules, which are only observed at 430K, are aligned arbitrarily, lying molecules lead to preferred in-plane alignments. It is shown that the type of epitaxy changes from a molecule alignment (along distinct gold directions) on samples grown at 430K and 330K to an alignment of crystallites on the 300−K film, which is obviously driven by a lattice match. In the latter case the molecule long axes are tilted by 3° to the ⟨11-2⟩ direction of the gold surface. This experimentally observed in-plane alignment could be verified by a lattice mismatch calculation. The excellent agreement between experiment and calculated results reveals that in the latter case the bulk structure of the film is retained down to the interface and that its alignment is affected by the lattice match of the interface surface lattices.

1 March 2006 in Journal of Nanoscience and Nanotechnology
Verified
Journal Article
Closed access
THT. Haber
T. Haber
MOM. Oehzelt
M. Oehzelt
RRRoland Resel
Roland Resel
AAA. Andreev
A. Andreev
ATA. Thierry
A. Thierry
WGW. Grogger
W. Grogger
This work focuses on studies of the single crystal nature of para-sexiphenyl structures grown on freshly cleaved KCl(100) surfaces. Two different kinds of morphologies, namely terrace like structures and needle like structures, are found by atomic force microscopy as well as by electron microscopy. Regardless of the morphology the individual crystallites show highly regular shapes. The crystalline alignment and the degree of order of the crystallites on the surface are determined by X-ray diffraction. Several epitaxial alignments of para-sexiphenyl on KCl(100) are observed and all of them are perfectly aligned on the surface. The rocking curve widths of the organic crystallites do not exceed 800″ which is approximately only the four fold of the substrates' ones. The single crystalline nature of para-sexiphenyl crystallites is proven by transmission electron microscopy, diffraction patterns, dark field imaging and high resolution techniques. Single crystalline terraced mounds reach diameters of several microns and heights of 50 nm. Single crystal needles show heights and breadths of more than 100 nm and lengths of several microns.

4 January 2008 in Journal of Crystal Growth
Verified
Journal Article
Closed access
THT. Haber
T. Haber
JIJ. Ivanco
J. Ivanco
MRM.G. Ramsey
M.G. Ramsey
RRRoland Resel
Roland Resel