Vapor phase deposition processes hold great potential for industrializing the deposition of perovskite-based absorbers, offering a pathway to commercialization.
Vapor phase deposition methods are readily able to achieve uniform coverage of large‐area substrates and are widely considered promising for industrial‐scale perovskite solar cell fabrication. However, as perovskite‐silicon tandem solar cells approach commercialization, practical considerations of manufacturing throughput come into play. Here, it is shown that the inherent sublimation characteristics of the organic precursor formamidinium iodide (FAI) make increasing the deposition rate of FA‐based co‐evaporated perovskites negatively impact replicability and lead to a substantial decrease in power conversion efficiency (PCE). These losses are linked to reduced film homogeneity and the emergence of carbon‐rich regions within the perovskite layer. To mitigate these rate‐induced effects, two approaches are explored: source layout optimization and material preconditioning. Utilizing dual FAI sources rather than a single FAI source reduces the relative PCE drop from ≈23% rel to ≈9% rel at a deposition rate of ≈18 nm min −1 (14.8% PCE @ maximum power point (MPP)) compared to the baseline rate of 5 nm min −1 (16.2% PCE @MPP). Alternatively, preconditioning a single FAI source reduces the performance losses from ≈31% rel to ≈26% rel at a deposition rate of ≈21 nm min −1 . These findings underscore the importance of tailored source strategies to enable high‐rate FA‐based co‐evaporated perovskites without compromising device performance.
Vapor phase deposition processes for the fabrication of perovskite solar cells show great potential for transferring from laboratory‐scale to continuous industrial‐scale production. Precise process control and high process reproducibility are of utmost importance to unlock their full potential. In this regard, the sublimation behavior and rate control of organic precursor materials in thermal evaporation processes are particularly challenging. Here, it is investigated in detail how the particle size of formamidinium iodide (FAI) and the crucible geometry influence the directionality of the emitted vapor flux. It is shown that conical crucibles lead to beam focusing of the vapor flux, while cylindrical crucibles show a broader, less directional emission profile. This leads to differences in the homogeneity of material deposition depending on the lateral source‐to‐substrate distance. Furthermore, there is a substantial impact of FAI particle size on the directionality of the vapor flux for conical crucibles, affecting the deposited material thickness gradient over the substrate. Analyzing commonly employed inorganic materials reveals the strong material dependence of effusion characteristics, leading to additional complexity for multi‐material deposition processes. The findings emphasize that both homogenization of organic precursor materials and optimization of source geometry and arrangement are critical for achieving uniform deposition and, consequently, improved process reproducibility.