20 April 2023 in Advanced Functional Materials
Oxide‐ion conductors are gaining attention as future materials in energy applications, such as solid oxide fuel cells. Many Bi‐containing compounds exhibit high oxide‐ion conductivity via conventional vacancy mechanism. However, interstitial oxide‐ion conduction is rare in Bi‐containing materials. Herein, high oxide‐ion conductivity is reported through interstitial oxygen sites in Sillén oxychlorides, LaBi2−xTexO4+x/2Cl (Bi2LaO4Cl‐based oxychlorides). Oxide‐ion conductivity of LaBi1.9Te0.1O4.05Cl is 20 mS cm−1 at 702 °C, and higher than best oxide‐ion conductors as Bi2V0.9Cu0.1O5.35 below 201 °C. Despite of the presence of Bi and Te species, LaBi1.9Te0.1O4.05Cl shows extremely high chemical and electrical stability at 400 °C from oxygen partial pressure 10−25 to 0.2 atm and high chemical stability under CO2 flow, wet 5% H2 in N2 flow, and air with natural humidity. Neutron scattering length density analysis, DFT calculations, and ab initio molecular dynamics simulations indicate that the extremely high oxide‐ion conduction is attributed to cooperative diffusion through interstitial oxygen sites (interstitialcy diffusion mechanism) in triple fluorite‐like layers. The present findings demonstrate the ability of LaBi2−xTexO4+x/2Cl as superior oxide‐ion conductors, which can open new horizons for oxide‐ion conductors.
1 November 2001 in IEEE Photonics Technology Letters
Conventional dispersion-slope compensation filters suffer from a fundamental tradeoff between the amount of dispersion-slope compensation and the compensation bandwidth. A novel multireflection device, composed of two coupled cavity filters in a parallel configuration is proposed that has an adjustable dispersion-slope independent of the compensation bandwidth. The device provides an adjustable dispersion-slope value between -6.7 and -35.7 ps/sup 3/ over a bandwidth of 3 nm. The center wavelength is adjustable over a 10-nm range.
1 July 2025 in Journal of the American Chemical Society
Mixed-anion perovskite compounds containing hydride ions (H–) are promising catalysts for ammonia synthesis under mild reaction conditions. Oxyhydride BaTiO3–xHx is a typical example, with a positive correlation between H– concentration x and catalytic activity; however, the previously reported topochemical synthesis achieved a maximum x value of ∼0.6. Herein, we significantly expand the H– solubility limit to ∼1 by using mechanochemical synthesis, wherein its nonthermal reaction condition enables oxyhydride formation rather than undesired metal-hydride formation and/or hydrogen desorption. The prepared Ru/BaTiO2H catalyst showed notable activity for ammonia synthesis (34 mmol g–1 h–1 at 400 °C and 0.9 MPa), which is much higher than that of the reported Ru/BaTiO2.5H0.5 catalyst. More surprisingly, when compared at the same H– concentration of x = 0.5, the mechanochemically prepared sample was approximately three times more active than the topochemically prepared sample. The Bragg coherent X-ray diffraction imaging (Bragg-CDI) technique revealed a non-negligible lattice strain in the mechanochemical product, not only at the surface but also inside the crystal, which is approximately ten times larger than that of the topochemical product, likely contributing to the enhanced catalytic activity. These findings indicate that mechanochemical synthesis enables the design of functional H–-based materials in terms of both the H– concentration and the lattice strain.
12 November 2024 in Chemical Communications
We successfully synthesized Li2NbHO2, the first example of a rock-salt-type transition-metal oxyhydride. Galvanostatic charge/discharge tests revealed that Li2NbHO2 functions as an electrode for lithium secondary batteries.
29 November 2025 in Small Structures
Hydride ions (H − ) are attracting increasing interest as alternative charge carriers to protons in electrochemical devices; however, the development of H – /e – mixed conductors remains challenging. Herein, we demonstrate a novel design strategy for hydride incorporation using oxide‐ion‐conducting transition metal oxides as precursors. Using Ba 3 V 2 O 8 as the precursor, we successfully synthesized the first palmierite‐type oxyhydride, Ba 3 V 2 H 0.5 O 7.5 (BVHO), via a topochemical ion exchange reaction. Structural analyses revealed that BVHO exhibits a unique crystal structure featuring a charge ordering of V 5+ or V 4+ at tetrahedral sites and V 3+ or V 2+ at octahedral sites, accompanied by a random distribution of H and O at the anion sites. Electrochemical impedance spectroscopy of a symmetric BVHO|Ba 1.75 LiH 2.7 O 0.9 |BVHO cell confirmed that BVHO functioned as a hydrogen reversible electrode. These results highlight the potential of oxide‐ion‐conducting oxides as effective precursors for creating novel oxyhydrides with distinct framework structures, thereby expanding the exploration space for H – ·e − mixed conductors.