Risha Na

Risha Na

Auto-generated profile, based on publicly available information

Risha Na

Electrical and Computer Engineering, The Ohio State University, Columbus, Ohio United States

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
4 August 2020 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
HYHaoyang You
Haoyang You
ZWZhuo Wei
Zhuo Wei
BHBoxue Hu
Boxue Hu
ZZZheng Zhao
Zheng Zhao
RNRisha Na
Risha Na
JWJin Wang
Jin Wang
The unprecedented high-speed switching of Wide Bandgap (WBG) power devices may change the partial discharge (PD) behaviors of power modules, busbars and loads. However, very little research has been published on PD behaviors under square-wave pulses with ultra-fast dv/dt. To address this problem, this paper studies PD behaviors of direct bonded copper (DBC) samples with different trench distances and chamfer radii under single and repetitive square pulses with ultra-fast dv/dt. The results show that for the single pulse excitation partial discharge inception voltage (PDIV) decreases with increasing rise time if the pulse width is shorter than 300 s, and PDIV decreases with increasing pulse width. For repetitive pulse excitation, PDIV increases linearly with trench distance if the chamfer radius is larger than 0.5 mm, while it follows a concave curve if the chamfer radius is less than 0.5 mm. On the other hand, for a fixed trench distance, the PDIV changes quadratically with the chamfer radius increasing from 0 mm (right angle) to 0.7 mm. Based on experimental results, a PD model with bubble expansion theory is to explain the PD mechanism under ultra-fast dv/dt excitation, and an empirical equation for PDIV prediction is also derived.

21 April 2020 in IEEE Transactions on Power Electronics
Verified
Journal Article
Open access
ZKZiwei Ke
Ziwei Ke
Jianyu PanJianyu Pan
Jianyu Pan
MSMuneer Al Sabbagh
Muneer Al Sabbagh
RNRisha Na
Risha Na
JZJulia Zhang
Julia Zhang
LXLongya Xu
Longya Xu
This work deals with the sizing of submodule capacitors for modular multilevel converters (MMCs) used for variable speed drives for medium voltage (MV) and high voltage (HV) electric machines. Variable speed drives are required to run over a wide frequency range from zero to a few hundred Hz or even over 1 kHz. Under low frequency operation (< 30 Hz), a large current ripple flowing through the MMC submodule capacitors will cause significant capacitor voltage fluctuation. This paper proposes an optimal submodule capacitor selection method based on the common-mode voltage injection. The proposed sizing model includes two functions: a) accurately estimating the capacitor voltage ripple based on the drive system parameters; and b) identifying the minimum capacitance of the submodule capacitors based on the allowed maximum capacitor voltage fluctuations. Simulation and experimental results show that the error between the actual and estimated values of the voltage fluctuation is within 3% using the proposed model.