Lithium metal batteries (LMBs) show great promise for achieving energy densities over 400 Wh·kg−1. However, highly flammable organic electrolytes are a long-lasting problem that triggers safety hazards and hinders the commercial application of LMBs. Here, a nonflammable diluted highly concentrated electrolyte (DHCE) with ethoxy(pentafluoro)cyclotriphosphazene (PFPN) as a diluent is developed to simultaneously achieve high safety and cycling stability of high-voltage LMBs. The optimal DHCE not only ensures reversible Li deposition/dissolution behavior with a superior average Coulombic efficiency (CE) over 99.1% on lithium metal anode (LMA), but also suppresses side reactions and stress crack on the LiCoO2 (LCO) under high cut-off voltage. The newly developed DHCE exhibits high thermal stability, showing complete nonflammability and reduced heat generation between the electrolyte and delithiated LCO/cycled LMA. This work offers an opportunity for rational designing nonflammable electrolytes toward high-voltage and safe LMBs.
Oxidized starch-graft-poly(styrene-butyl acrylate) [OS-g-P(St-BA)] latex was synthesized by the graft copolymerization of OS with St and n-butyl acrylate (BA) via emulsion polymerization. The graft copolymers were characterized by Fourier transform infrared (FT-IR), transmission electronic microscopy (TEM), dynamic light scattering, thermogravimetry (TG), and differential scanning calorimetry (DSC). The effects of the amount of OS, monomers, and initiator on graft copolymerization were investigated. Under the optimal conditions, the percentage of graft (PG), grafting efficiency (GE), and ζ potential could reach 256.5%, 41.7%, and -30.1 mV, respectively. The results indicated that the OS grafted onto particles greatly enhanced the colloidal stability of latex. The thermal stability properties of OS-g-P(St-BA) were also improved by the addition of OS. The OS-g-P(St-BA) latex may be used to partly replace the conventional synthetic latex for paper coating.
Maleic anhydride (MAH)–divinyl benzene (DVB) multi-monomer melt-grafting onto isotactic polybutene-1 (iPB-1) was carried out in a torque rheometer. The effects of dicumyl peroxide (DCP), MAH, and DVB concentrations, and temperature, on the reaction, were investigated. The optimized conditions were 170 °C, DVB/MAH = 4:6 (mass ratio). DVB as a comonomer enhanced the grafting degree (Gd) and grafting efficiency (Ge) of iPB-g-MAH better than styrene. The initiator DCP had little effect on Gd as its concentration over 0.2 phr, but the grafts’ melt flow rate (MFR) increased significantly, and relative molecular weight decreased remarkably with increased DCP concentration. With increasing Gd, the contact angle of grafts with water decreased, and there was a larger crystallization rate. The study of iPB-1 and iPB-g-MAH (Gd = 1.5%)-modified polyamide 6 (PA6) showed that iPB-g-MAH had an obviously toughening effect on PA6. With increasing iPB-g-MAH concentration, the blends of impact strength and elongation at break increased obviously, tensile strength decreased slightly, and MFR decreased prominently, which greatly slowed the processing degradation of PA6. The properties of iPB-1/PA6 blends deteriorated. Both DSC curves and SEM micrographs confirmed that PA6/iPB-g-MAH blends had much better compatibility than PA6/iPB. The reason was that the anhydride group in iPB-g-MAH reacted with amide group in PA6 to improve the compatibility between two phases, and iPB-g-MAH is an excellent modifier for PA6.