20 August 2019 in Geothermal Energy
HPHimawan Tri Bayu Murti Petrus
Himawan Tri Bayu Murti Petrus
MNMuhammad Istiawan Nurpratama
Muhammad Istiawan Nurpratama
The utilization of geothermal energy remains underdeveloped, mainly due to the technical problem of silica scaling. The scaling can eventually disrupt the electricity production process due to frequent pipe maintenance. Although inevitable, scaling can be controlled by accelerating the precipitation process through the addition of silica seeds. Silica gel has an affinity to bind with dissolved silica in geothermal brine that therefore reduces the likelihood of silica to form scale on the pipeline surfaces. In the present work, brine was taken from geothermal well Unit 3A–3B at the Dieng geothermal power plant with an initial silica monomer concentration of approximately 420 ppm. Silica gel seeds were added to the brine at a precise pH and temperature and dissolved silica concentration was analyzed by detecting silica monomers with UV–visible spectrophotometry using the vanadate/molybdate (yellow) method. Experimental results showed that the silica concentration in the liquid phase could be reduced by the addition of these seeds. Silica precipitation was determined by mass transfer of silica monomers from the fluid phase onto solid surfaces, and it was found that precipitation decreased as pH and temperature increased. Calculations also showed that the mass transfer coefficient was enhanced by fluid agitation. The silica precipitation process was optimal at a pH of 7, a temperature of 40 °C and agitation speed of 800 rpm; the result was a mass transfer coefficient of 0.5924 cm/s. In a dimensionless correlation, the mass transfer coefficient can be expressed in the equation (kc·dp/DAB) = 1.4242·Re0.529·Sc0.3333.
1 April 2021 in Journal of Cleaner Production
HPHimawan Tri Bayu Murti Petrus
Himawan Tri Bayu Murti Petrus
+4
1 October 2020 in Journal of Environmental Chemical Engineering
HPHimawan Tri Bayu Murti Petrus
Himawan Tri Bayu Murti Petrus
+1
16 January 2021 in Bulletin of Chemical Reaction Engineering & Catalysis
In this study, the optimization of microwave-assisted alkaline (MAA) pretreatment is performed to attain the optimal operating parameters for the delignification of cocoa pod husk (CPH). The MAA performance was examined by heating the CPH solid with different particle sizes (60–120 mesh) and NaOH solution with a different sample to a solvent (SS) ratio (0.02–0.05 g/L), for short irradiation time (1–4 min). Box-Behnken Design (BBD) was utilized to optimize the percentage of lignocellulose composition changes. The results show that by enlarging particle size, the content of lignin and cellulose decreased while hemicellulose increased. By prolong irradiation time, the content of lignin and hemicellulose decreased while cellulose elevated. On the other hand, increasing the SS ratio was not significant for hemicellulose content changes. From FTIR and SEM characterization, the MAA drove the removal of lignin and hemicellulose of CPH and increased cellulose slightly. Supported by kinetic study which conducted in this work, it was exhibited that MAA pretreatment technology is an effective delignification method of CPH which can tackle the bottleneck of its commercial biofuel production. Copyright © 2021 by Authors, Published by BCREC Group. This is an open access article under the CC BY-SA License (https://creativecommons.org/licenses/by-sa/4.0).
25 January 2021 in International Journal of Technology
TAThya Laurencia Benedita Araujo
Thya Laurencia Benedita Araujo
Known as a promising protein source, black soldier fly (BSF) larva has attracted the attention of many researchers. BSF larvae have the ability to convert organic waste into protein. However, the growth modeling of this process has not been studied previously. Hence, this study generated a BSF larvae growth model to explain BSF larvae production. Vegetable and fruit waste collected from the Gamping fruit market was used as the growth media. The weight of larvae and the leftover substrate were measured for 20 days. The substrate consumed was related to larvae body mass. The model was properly fitted with R-squared values of 0.9988 and 0.9312 for the substrate consumption and larvae growth, respectively. The value of the kinetics constants in this study were 0.847 +/- 0.018 g(-0.5 )day(-1) for 0.058 +/- 0.019 g(-0 5) day(-1) for k(2); and 0.007 +/- 0.013 g(-1.0) day(-1) for k(3).
28 September 2019 in Asian Journal of Chemistry
Fresh neem leaves (Azadirachta indica A. Juss) consist of quercetin (flavonoid) compound, responsible for yellow colour as a natural dye. The study investigated the variable optimization in fresh neem leaf extraction process and its application. The optimization was conducted using response surface methodology (RSM) and ANOVA test. The coefficients of determination (R2) were generalized at 96.46 and 96.39 % for optimizing extraction process and application process parameter of natural dyes from neem leaves, respectively. The optimum variables for the extraction process were obtained at 50 % w/v feed-solvent ratio, the temperature of 80 ºC and extraction duration of 80 min with the response concentration of 46.19 g/L. Furthermore, the optimum variable on the application of natural dyes from neem leaves was recorded when alum was applied as fixator as much as 14.09 g/L and Turkish red oil (TRO) as mordant at 11.16 g/L resulted the response of 0 % on the degree of faded.