13 November 2023 in Applied Physics Letters
A HfO2/Al2O3/AlN stack deposited in a plasma-enhanced atomic layer deposition system is used as the gate dielectric for GaN metal–insulator–semiconductor structures. Prior to the deposition, in situ remote plasma pretreatments (RPPs) with O2, NH3, and NH3–O2 (in sequence) were carried out. Frequency-dependent capacitance–voltage (C–V) measurements reveal that for all the RPP-treated samples, the interface trap density Dit was significantly reduced compared to the sample without RPP. In particular, the NH3-treated sample exhibits an extremely low Dit of ∼1011 cm−2·eV−1 from EC − 0.31 eV to EC − 0.46 eV. To characterize the interface traps at deeper levels, the transfer pulsed I–V measurement was employed further. In the energy range of EC − ET > 0.54 eV, the interface trap charge density Qit of various samples demonstrates the following order: NH3 RPP < NH3–O2 RPP < O2 RPP < without RPP. By adjusting multiple pulse widths, the Dit derived from the Qit result matches the C–V measurement precisely. Moreover, X-ray photoelectron spectroscopy analysis of the Ga 3d core-level indicates that NH3 RPP facilitates the conversion of Ga2O into GaN at high RF power of 2500 W, whereas O2 RPP mainly oxidizes GaN to relatively stable Ga2O3. Combined with the C–V and pulsed I–V measurements, it is confirmed that a strong positive correlation exists between Ga2O and the interface traps, rather than Ga2O3.
9 September 2022 in Journal of Applied Physics
We implemented invisibility criterion and black–white contrast orientation analysis into low-tilt electron channeling contrast imaging (ECCI) for dislocation-type discrimination in GaN and AlGaN layers grown on a Si(111) substrate. Our ECCI and x-ray diffraction (XRD) analysis attained consistent threading dislocation densities for GaN and AlGaN grown on Si, but demonstrated drastic discrepancy in the percentage of edge-type dislocations, potentially due to the lack of appropriate consideration of mixed-type dislocations in XRD. Further ECCI analysis of GaN/AlGaN heterointerface revealed mixed-type dislocation half-loops and dislocation bending due to compressive strain relaxation, validating that not all the dislocations originated from the mosaic or columnar structure. As a result, XRD analysis based on the mosaic block model does not give reliable edge-to-screw dislocation ratio. The observation of classic van der Merwe–Matthews-type dislocation half-loop nucleation and dislocation gliding could be associated with potential GaN/AlGaN optoelectronic device degradation issues.
8 July 2024 in Applied Physics Letters
InGaN-based micro-light-emitting diodes (LEDs) grown on Si have gained tremendous interest for full-color displays. Strain management is a key challenge for the epitaxial growth of InGaN-based long-wavelength LEDs on Si because the accumulated compressive strain can severely limit In incorporation and degrade the quality of InGaN multi-quantum wells (MQWs) when the conventional Al-composition step-graded AlN/AlGaN buffer is used for strain control. In this work, we demonstrate a promising approach to effectively reduce the in-plane residual compressive stress of GaN by using an AlN single-layer buffer. The in-plane lattice parameter of the GaN underlayer was increased from 3.183 to 3.189 Å with the residual compressive stress at room temperature reduced from 0.37 to ∼0 GPa, which significantly improved the In incorporation of InGaN MQWs and extended the photoluminescence wavelength from 510 to 550 nm. A remarkably high internal quantum efficiency of 78% was thus achieved for the as-grown InGaN-based green LEDs on Si. This work paves the way for the growth of high-efficiency InGaN-based long-wavelength micro-LEDs.
14 November 2022 in Journal of Physics D: Applied Physics
The paramount issues facing commercialization of GaN-on-Si RF devices include the inevitable wafer bowing and large thermal resistance when incorporating the conventional AlN/AlGaN multilayer or superlattice buffer for stress control. The large thermal resistance due to the strong phonon scattering by the AlGaN alloy and multiple interfaces of the AlN/AlGaN multilayer or superlattice buffer must be carefully addressed, which can significantly affect the performance and reliability of GaN-on-Si RF devices. In this letter, we report a successful growth of crack-free 2 μm-thick GaN film on 6 inch high-resistivity (>10 kΩ cm) Si with a single-layer AlN buffer. By virtue of a quasi-2D GaN nucleation on the AlN buffer layer, the as-grown GaN-on-Si wafer presents a tremendous reduction in warpage from 800 to less than 8 μm, while preserving a high crystalline quality. The full width at half maximum of x-ray diffraction of GaN (0002) and (10 2) planes are 457 and 509 arcsec, respectively, and the residual stress is as low as 0.2 GPa. The underlying physical mechanisms of the quasi-2D GaN nucleation layer involved in stress engineering and dislocation annihilation have been discussed in detail. This work paves the way for the fabrication of low-cost and high-performance GaN RF devices grown on HR-Si.
10 February 2025 in Applied Physics Letters
In this work, the mechanism of RF loss up to 110 GHz for N-polar GaN has been studied. With the assistance of S-parameter characterization combined with secondary ion mass spectroscopy analyses, the incorporated oxygen impurity has been identified to be the main source bringing about the severe RF loss of N-polar GaN. The compensation of Fe-doping enables an effective reduction in RF loss. Moreover, the unintentionally doped (UID) GaN layer grown on top of the Fe-doped GaN buffer requires a careful design due to the distinct memory effect of Fe-doping in N-polar GaN. With an optimization of its thickness, a very low RF loss of 0.36 dB/mm at 94 GHz has been attained. Furthermore, by fitting the Fe concentration profile of UID-GaN according to the mass balance rate equation, it is found that the desorption of Fe on the N-polar GaN surface is significant. A bond-based model is introduced to elucidate the difference of the Fe memory effect between Ga-polar and N-polar GaN.
21 May 2024 in Semiconductor Science and Technology
The impacts of eliminating access regions (AR) on DC and thermal performance of GaN-based MIS-HEMT have been studied using a device of 4 µm gate length. Nominal absence of ARs was achieved by a metal-organic chemical vapor deposition-regrown heavily n-doped GaN contact region extended to the two-dimensional electron gas (2DEG) channel (with sheet resistance as low as 14 Ω/ and ohmic contact resistance of 0.20 mm) and 22-nm-thick AlN/Al2O3/HfO2 insulator layers acting as both gate dielectrics and sidewall spacers. As a result, a low knee voltage (2.5 V @ = +2 V) comparable to deeply-scaled devices was attained, revealing the dominant role of ARs in knee voltages. High linearity at lower supply voltages (gate voltage swing of 7.3 V @ = 5 V) and a faster GVS saturation trend with V
DS
increasing were observed, benefiting from the improved utility of applied lateral voltage. Moreover, a much lower thermal resistance compared to that of the conventional MIS-HEMT structure (146 vs. 202 K W−1) was extracted by a static-pulsed I-V measurement method. Simplified TCAD simulations were conducted to explain the underlying mechanisms, demonstrating that the enhanced surface heat flow covered by the gate metal as well as the more uniform electric field along the 2DEG channel accounts for the better capability of heat management in the device free of ARs. Our results indicate the size of DC and thermal performance enhancements obtained by eliminating ARs in a GaN-based MIS-HEMT structure.