4 July 2023 in IEEE Journal of Solid-State Circuits
This article introduces a silicon-based source that can radiate power from the lower end of the terahertz (THz) spectrum into the far-infrared region. The radiator consists of a millimeter-wave (mm-wave) oscillator that drives a PIN diode multiplier. The p-i-n diodes exhibit reverse recovery when driven strongly, and the diode switches a large amount of current in a short interval. This process is highly non-linear and generates a harmonic-rich waveform, which is utilized here for higher harmonic generation. An on-chip folded dipole antenna is used to radiate the generated THz signal. The harmonic radiation properties of the folded dipole are analyzed and presented here. Wireless harmonic injection locking is also demonstrated in this work in order to synchronize the chip to an external source. Designed in GlobalFoundries 90-nm SiGe BiCMOS process, the chip has an effective isotropic radiated power (EIRP) of 13 dBm and −14.2-dBm radiated power at 0.39 THz. The chip is characterized up to 0.8 THz using Virginia Diodes (VDI) mixers, and an EIRP of −3.8 dBm is measured at 0.78 THz. In order to measure the radiated tones at higher frequencies, Fourier-transform infrared (FTIR) spectroscopy is used with a room-temperature deuterated triglycine sulfate (DTGS) detector. Measurement results confirm the presence of tones extending from the THz region into the far-infrared region, with an SNR of 18.4, 14, 9.3, and 6.7 dB at 1.17, 2.21, 3.25, and 4.03 THz, respectively. This work is the first demonstration of a silicon source capable of generating detectable tones at far-infrared frequencies.
9 December 2022 in IEEE Journal of Microwaves
Terahertz (THz) external-cavity lasers based on quantum-cascade (QC) metasurfaces are emerging as widely-tunable, single-mode sources with the potential to cover the 1--6 THz range in discrete bands with milliwatt-level output power. By operating on an ultra-short cavity with a length on the order of the wavelength, the QC vertical-external-cavity surface-emitting-laser (VECSEL) architecture enables continuous, broadband tuning while producing high quality beam patterns and scalable power output. The methods and challenges for designing the metasurface at different frequencies are discussed. As the QC-VECSEL is scaled below 2 THz, the primary challenges are reduced gain from the QC active region, increased metasurface quality factor and its effect on tunable bandwidth, and larger power consumption due to a correspondingly scaled metasurface area. At frequencies above 4.5 THz, challenges arise from a reduced metasurface quality factor and the excess absorption that occurs from proximity to the Reststrahlen band. The results of four different devices — with center frequencies 1.8 THz, 2.8 THz, 3.5 THz, and 4.5 THz — are reported. Each device demonstrated at least 200 GHz of continuous single-mode tuning, with the largest being 650 GHz around 3.5 THz. The limitations of the tuning range are well modeled by a Fabry-Pérot cavity which accounts for the reflection phase of the metasurface and the effect of the metasurface quality factor on laser threshold. Lastly, the effect of different output couplers on device performance is studied, demonstrating a significant trade-off between the slope efficiency and tuning bandwidth.
30 October 2024 in ACS Photonics
Harmonic and subharmonic RF injection locking is demonstrated in a terahertz (THz) quantum-cascade vertical-external-cavity surface-emitting laser (QC-VECSEL). By tuning the RF injection frequency around integer multiples and submultiples of the cavity round-trip frequency, different harmonic and subharmonic orders can be excited in the same device. Modulation-dependent behavior of the device has been studied with recorded lasing spectral broadening and locking bandwidths in each case. In particular, harmonic injection locking results in the observation of harmonic spectra with bandwidths over 200 GHz. A semiclassical Maxwell-density matrix formalism has been applied to interpret QC-VECSEL dynamics, which aligns well with experimental observations.
24 October 2025 in ACS Photonics
7 May 2024 in Optics Express
The effects of optical feedback on a terahertz (THz) quantum-cascade metasurface vertical-external-cavity surface-emitting laser (QC-VECSEL) are investigated via self-mixing. A single-mode 2.80 THz QC-VECSEL operating in continuous-wave is subjected to various optical feedback conditions (i.e., feedback strength, round-trip time, and angular misalignment) while variations in its terminal voltage associated with self-mixing are monitored. Due to its large radiating aperture and near-Gaussian beam shape, we find that the QC-VECSEL is strongly susceptible to optical feedback, which is robust against misalignment of external optics. This, in addition to the use of a high-reflectance flat output coupler, results in high feedback levels associated with multiple round-trips within the external cavity-a phenomenon not typically observed for ridge-waveguide QC-lasers. Thus, a new theoretical model is established to describe self-mixing in the QC-VECSEL. The stability of the device under variable optical feedback conditions is also studied. Any mechanical instabilities of the external cavity (such as vibrations of the output coupler), are enhanced due to feedback and result in low-frequency oscillations of the terminal voltage. The work reveals how the self-mixing response differs for the QC-VECSEL architecture, informs other systems in which optical feedback is unavoidable, and paves the way for QC-VECSEL self-mixing applications.