26 January 2024 in IEEE Journal of Solid-State Circuits
This article introduces an efficient high-power radiator at 400 GHz and a fully integrated transceiver supporting OOK modulation for high-speed wireless communication using 90-nm SiGe BiCMOS. The reverse recovery of silicon p-i-n diodes is used to design a frequency quadrupler that generates high power efficiently at 400 GHz. By mutually interlocking and combining the power from two such quadruplers, we design a 400-GHz radiator. The proposed design achieves a peak effective isotropic radiated power (EIRP) of +20.6- and −5.8-dBm radiated power at 398 GHz with 0.2% dc-to-THz radiation efficiency. This is the highest reported efficiency, and THz power radiated per element above 320 GHz. Using the p-i-n diode quadruplers as the LO, we design a 400-GHz OOK transmitter and receiver with on-chip antennas. The transmitter uses a multiplier-last approach and has an EIRP of +17 dBm while consuming 84-mW dc power. The receiver uses fundamental-driven passive mixer architecture to achieve a noise figure (NF) of 25 dB while consuming 184 mW of dc power. This is the lowest reported NF above 320 GHz. Over-the-air (OTA) measurements are performed for a 5-cm link with OOK modulation. The stand-alone transmitter supports a data rate of 10 Gb/s (8 pJ/bit), and the transmit–receive system supports a data rate of 5 Gb/s (36.8 pJ/bit for the receiver). This is the first demonstration of a fully integrated multi-Gb/s wireless transceiver above 320 GHz in silicon.
4 July 2023 in IEEE Journal of Solid-State Circuits
This article introduces a silicon-based source that can radiate power from the lower end of the terahertz (THz) spectrum into the far-infrared region. The radiator consists of a millimeter-wave (mm-wave) oscillator that drives a PIN diode multiplier. The p-i-n diodes exhibit reverse recovery when driven strongly, and the diode switches a large amount of current in a short interval. This process is highly non-linear and generates a harmonic-rich waveform, which is utilized here for higher harmonic generation. An on-chip folded dipole antenna is used to radiate the generated THz signal. The harmonic radiation properties of the folded dipole are analyzed and presented here. Wireless harmonic injection locking is also demonstrated in this work in order to synchronize the chip to an external source. Designed in GlobalFoundries 90-nm SiGe BiCMOS process, the chip has an effective isotropic radiated power (EIRP) of 13 dBm and −14.2-dBm radiated power at 0.39 THz. The chip is characterized up to 0.8 THz using Virginia Diodes (VDI) mixers, and an EIRP of −3.8 dBm is measured at 0.78 THz. In order to measure the radiated tones at higher frequencies, Fourier-transform infrared (FTIR) spectroscopy is used with a room-temperature deuterated triglycine sulfate (DTGS) detector. Measurement results confirm the presence of tones extending from the THz region into the far-infrared region, with an SNR of 18.4, 14, 9.3, and 6.7 dB at 1.17, 2.21, 3.25, and 4.03 THz, respectively. This work is the first demonstration of a silicon source capable of generating detectable tones at far-infrared frequencies.
1 January 2026 in IEEE Microwave and Wireless Technology Letters