12 July 2021 in IEEE Transactions on Nuclear Science
At the ELBE Center for High-Power Radiation Sources, electrons are accelerated to an energy of up to 40 in a superconducting linear accelerator that is operated in continuous wave mode. The acceleration is achieved using superconducting RF cavities, which are driven by an analogue low level RF system and solid-state based RF amplifiers. The analogue low level RF system was transformed to a digital system based on the MicroTCA standard. It is in user operation since 2020. Here the new digital system and its integration in the ELBE control system is described. Furthermore, the system is characterised by noise measurements and shows RMS field stability of the digital low level RF system of 0.01° in phase and 0.005% in amplitude. In addition, an algorithm for compensating long term drifts is presented and characterised.
16 March 2020 in IEEE Transactions on Nuclear Science
Vacuum tube amplifiers are the most widespread type of Radio Frequency (RF) sources used to produce high power signals needed for beam acceleration in superconducting cavities. At Deutsches Elektronen-Synchrotron (DESY), megawatt rated klystrons are used to produce millisecond-long RF shots for pulsed operation in particle accelerators. In contrast, inductive output tubes are used to provide a continuous RF signal for Continuous Wave (CW) operation. In both cases, the amplifiers suffer from amplitude dependent nonlinearity between the driving and generated signals. This nonlinearity complicates the setup operations of the Low Level RF (LLRF) system and makes it harder to regulate the accelerating field. Therefore a way to linearize the amplifier is highly valuable. This paper covers the design, implementation, and test of an FPGA-based predistortion linearization unit. The first results on the performance of this component in linearizing the amplifiers of running CW and pulsed superconducting accelerators are presented. Such a component uses programmable interpolating Look Up Tables (LUT) that are addressed using the squared value of the requested signal amplitude. This component only adds 64 ns latency to the RF control system without relying on any vendor-dependent FPGA component. Other benefits of using programmable interpolating LUT are low FPGA usage of FPGA resources and flexibility in terms of the type of amplifier to be corrected. The benefits of using this linearizer for klystrons and inductive output tubes are presented and quantified.