For solving the problems of high solubility in electrolytes, poor conductivity and low active site utilization of organic electrode materials, in this work, 1,4,5,8-naphthalenetetracarboxylic dianhydride (NTCDA) grafted nickel phthalocyanine (TNTCDA-NiPc) was synthesized and used as an anode material for lithium ion batteries. As a result, the dispersibility, conductivity and dissolution stability are improved, which is conducive to enhancing the performance of batteries. The initial discharge capacity of the TNTCDA-NiPc electrode is 859.8 mA h g−1 at 2 A g−1 current density, which is much higher than that of the NTCDA electrode (247.4 mA h g−1). After 379 cycles, the discharge capacity of the TNTCDA-NiPc electrode is 1162.9 mA h g−1, and the capacity retention rate is 135.3%, which is 7 times that of the NTCDA electrode. After NTCDA is grafted to the phthalocyanine macrocyclic system, the dissolution of the NTCDA in the electrolyte is reduced, and the conductivity and dispersion of the NTCDA and phthalocyanine ring are also improved, so that more active sites of super lithium intercalation from NTCDA and phthalocyanine rings are exposed, which results in better electrochemical performance. The strategy of grafting small molecular active compounds into macrocyclic conjugated systems used in this work can provide new ideas for the development of high performance organic electrode materials.
A porous MA–VA–PcNi polymer was prepared by grafting nickel phthalocyanine (PcNi) onto the main chain of a maleic anhydride–vinyl acetate (MA–VA) polymer, and an MA–VA–PcNi electrode is prepared by electrospinning technology to inhibit the agglomeration of the active powder effectively, which produces spherical particles with a diameter of 100–300 nm. The synthesized MA–VA–PcNi polymer is used as the anode for lithium-ion and sodium-ion batteries, exhibiting excellent energy storage behaviors. The MA–VA–PcNi/Li battery displays a high capacity of 610 mA h g−1 and can still remain at 507 mA h g−1 with a retention rate of 83.1% after 400 cycles at a current density of 200 mA g−1. Even at a high current density of 2 A g−1, the specific capacity can remain at 195 mA h g−1. In addition, the MA–VA–PcNi/Na battery displays a high capacity of 336 mA h g−1 and can still remain at 278 mA h g−1 with a retention rate of 82.7% after 400 cycles at a current density of 100 mA g−1. A high specific capacity of 164 mA h g−1 can also be achieved at a high current density of 1 A g−1. After nickel phthalocyanine (PcNi) was grafted onto the MA–VA polymer, aggregation between phthalocyanine rings was effectively prevented, and this exposes more active sites. At the same time, the spherical particles obtained by electrospinning technology further improve the dispersion and increase the number of active sites of the active materials. Finally, the electrode materials show excellent energy storage behavior for lithium-ion and sodium-ion batteries, which provides a new idea for designing high-performance energy storage materials for organic electrodes.
The graphite-likePTCDA-1100hard carbon is prepared, which exhibits mixed porous structure with wider layer spacing, larger specific surface area and more exposed active points. As a result, superior rate cycle behaviors for bothPTCDA-1100/Lihalf-batteries andPTCDA-1100/NCM-811full batteries are observed.