1 March 2022 in International Journal of Lightweight Materials and Manufacture
1 March 2011 in Russian Metallurgy (Metally)
The effect of the strain rate on the texture and strength characteristics of electrical copper is analyzed using an industrial experiment on low- and high-speed wire drawing. The mechanical properties of the product are determined. The strength of the wire drawn at a high speed is found to be about 20 MPa higher than that of the wire drawn at a low speed. Metallographic analysis shows no differences in the wire structures, and texture analysis reveals differences in the behavior of dominant texture components. The directions of the dominant texture components are found to rotate near the periphery of the workpiece (i.e., at the workpiece surface). The solution of the drawing problem by the finite element method demonstrates an analogous rotation of the principal elongation directions.
1 July 2018 in Metallurgist
1 January 2017 in AIP Conference Proceedings
The role of additive manufacturing is noted for the construction of titanium medical implants. The purpose of the study is to determine the Young’s modulus of cellular titanium implants, which is based on calculations performed by finite element analysis. A honeycomb structure from intersecting cylinder surfaces is offered for the implant made of the Ti-6Al-4V alloy. Boundary conditions are stated for the loading of the implant structure. It is demonstrated that the Young’s modulus can be reduced more than three times comparing to a solid titanium alloy. Zones of strain and stress localization located near the abutment of the cylindrical surfaces. Recommendations for the further improvement of the implant architecture are generated.
23 April 2015 in Physics of Metals and Metallography
Experiments on the annealing of hot-rolled oxygen-containing copper in the temperature range of 300–700°C have been performed and the properties and the structure of the metal after this treatment have been investigated. The mechanical properties were studied by constructing tensile stress-strain curves and by determining the ultimate tensile strength, offset yield stress, percentage elongation, reduction of the area, hardness, and modulus of elasticity. The structural studies were performed using optical and electron microscopy. It has been established that the most substantial decrease after annealing at temperatures above 500°C is characteristic of the offset stress (by 62% for copper annealed at 600°C). The spheroidization of pores around the particles of copper oxides at the annealing temperature of 600°C has been revealed. It has been established that the annealing of the hot-rolled copper at temperatures of 500–600°C leads to an increase in the plastic properties of the metal due to the development of the mechanism of the spheroidization of pores and a decrease in the effect of stress concentrators.
1 November 2012 in Russian Metallurgy (Metally)
The forming of copper near a copper oxide particle is determined during multiple-pass drawing. The interaction of the copper oxide particle with copper is studied by the calculation of the state of stress in a finite element formulation and using scanning electron microscopy data. The results obtained demonstrate that pores appear around copper oxide particles when strain accumulates in multiple-pass drawing machines. The pore length increases with the accumulated strain, which can result in breaks of a wire in a highly cold-worked state.