The increasing global interest in geologic carbon storage as a feasible way of reducing CO2 atmospheric levels requires extensive onshore high-resolution seismic investigations to characterize suitable storage sites, for example, close to major CO2 emitters. To partly address this challenge and to acquire quality data at shallower and greater depths in a cost- and time-effective approach, a tailored acquisition scheme is adopted and tested at a candidate site in Stenlille, Denmark. The survey aims to understand whether an anticline reservoir structure known to exist at a 1000 m depth can serve for long-term CO2 storage and presents the structural integrity for this purpose. The data are recorded using a combination of nodal arrays, spaced at 10 m in a fixed geometry, and a set of more closely (2 m) spaced digital recorders, mounted on a landstreamer, which was moved at each shot location. Two 12 t mini vibrators are used as seismic sources. The nodal and landstreamer data sets are compared and combined into a unique data set for reflection imaging purposes along five profiles with a total length of approximately 12 km. The seismic sections obtained using this tailored combination of different recorders provide images of the entire shallow and deeper structures with an unprecedented resolution at the different depth levels necessary to assess the full potential of the suggested CO2 storage reservoir. The results significantly increase the existing knowledge of the extent and structural closure of the reservoir as well as a possible fault, all of which are critical for future risk analysis and planning of the storage.
Strong global actions for climate change include carbon capture and storage (CCS) as a feasible solution to reach carbon neutrality and raise opportunities for detailed subsurface investigations. An acquisition set-up designed for onshore-offshore zones was maximized for wide-scale high-resolution structural imaging and implemented to cover a domal structure of interest for CCS utilization close to the town of Havnsø (Denmark). The challenges of the combined acquisition and processing of land and marine multisensor data along a 42 km seismic profile are analyzed, the suggested solutions are applied, and the limitations are discussed. On the onshore side, a nodal array and a seismic landstreamer system were simultaneously used, whereas along the transition zone, a marine seismic streamer and ocean-bottom seismometers were added to record the seismic response generated by two seismic vibrator sources. The adopted sensing domains (velocity, acceleration, and pressure) were studied, and different processing steps were evaluated to enable their processing and subsequent data set merging. Results suggest, as the best approach, a separate prestack processing of the different data sets and the computation of new geometries and new surface-consistent residual static correction after their merging. The data acquired in the transition zone illuminate, for the first time, the subsurface geology of the region, delineating an expected domal closure. The final seismic section shows high continuity of the reflections with good resolution along the entire profile, identifying the main reservoir structure and the surrounding areas, which are important to ensure reservoir integrity and safe exploitation over longer time scales. Shallow and deep reflections are consistent with the stratigraphic column from a well log near the profile. The presented study shows a comprehensive workflow for processing such a multisensor data set in onshore and transition zone settings.
10 August 2024 in International Journal of Greenhouse Gas Control
In hard-rock mineral exploration using reflection seismic imaging, standard methods to estimate the static corrections based on the analysis of seismic body waves might be ineffective due to near-surface complexities. A workflow to estimate the P-wave statics based on high-resolution surface-wave (SW) tomography is adopted. We combine the S-wave velocity model retrieved by SW tomography, a method known for its high resolution, with the Poisson’s ratio estimated by the wavelength-depth method, a technique based on the analysis of skin depth of SWs. We apply the workflow to a 2D data set recorded at a phosphate mining site in Finland and to a 2D data set acquired at an iron-oxide mining site in Sweden. The retrieved models and statics are evaluated using prior information, and the stacked sections are compared with the ones resulting after standard body-wave statics. Improvements in the continuity of deep reflectors and increase in the extent and the amplitude of the horizons associated with the orebodies are evident in the stacked sections whose statics are computed with our workflow that we call SW tomostatics.