27 May 2026 in Bulletin of the National Technical University "KhPI". Series: Chemistry, Chemical Technology and Ecology
The paper evaluates the activity of regenerated acetone synthesized in the ECO PLUS 122 thermal distillation unit and verifies whether the regenerated solvent is physicochemically safe and can be functionally useful for coating and film application or not. Five contamination levels (ACN0-ACN4) were determined by moisture content, acid number, color value, density, non-volatile residue and evaporation behavior. Thermal profile analysis was performed to describe the boiling behavior of the solvent recovery, and the degree of regeneration and residue formation was measured for all contamination categories. Physicochemical measurements of the regenerated fractions (RACN0-RACN4) were used to evaluate the recovery of solvent purity, and coating-film tests were performed to measure evaporation rate, film uniformity index and gloss at 60o. The results showed that acetone is well recovered with a recovery yield of 94.8% (ACN0) to 85.1% (ACN4). The recovered fractions have low moisture content (0.03-0.12%), low acid number (0.02-0.06 mg KOH/g), low color index and low non-volatile residue content (0.002-0.016%). Coating film tests showed that the recovered acetone is functionally suitable for use in auxiliary paint operations: uniformity and gloss are within acceptable limits, and the evaporation behavior is similar to that of conventional industrial acetone. Overall, the experiment shows that acetone obtained using the ECO PLUS 122 process can be reused in coating activities without harming the solvent and without significantly increasing waste generation and raw material use in paint plants.
4 June 2026 in Integrated Technologies and Energy Saving
Complex interactions among formulation chemistry, film integrity, and interfacial sta-bility determine the anticorrosion performance of industrial primer-enamel coating systems. In this study, the influence of key formulation variables on coating quality indicators and cor-rosion behavior was systematically investigated using industrial epoxy-based primers and al-kyd/acrylic enamels. Particular attention was given to the role of zinc phosphate content, or-ganic corrosion inhibitors, and silane adhesion promoters under controlled technological con-ditions. Eight primer-enamel variants were prepared based on identical binder systems and application regimes, differing only in formulation parameters. All coatings were applied to steel substrates under standardized surface preparation, curing, and film formation conditions. Coating quality indicators, including dry film thickness, adhesion to steel, film compactness, defect tendency, and functional inhibitor activity, were evaluated to characterize film integrity before corrosion assessment.Corrosion resistance trends were subsequently analyzed using a comparative frame-work that emphasizes relative performance differences among formulation variants. The results demonstrate that coating performance cannot be attributed to a single factor. Increased zinc phosphate content primarily enhanced barrier continuity and film compactness, while silane adhesion promoters significantly improved interfacial bonding and reduced susceptibil-ity to underfilm corrosion. Organic corrosion inhibitors contributed independently to corro-sion suppression by limiting electrochemical activity at the metal-coating interface without altering bulk film morphology. The highest corrosion resistance was observed for formula-tions combining enhanced barrier properties, strong adhesion, and active inhibitor functionali-ty, indicating a synergistic interaction between structural and functional protection mecha-nisms.The findings establish clear formulation-performance relationships for industrial pri-mer-enamel systems and highlight the importance of balanced chemical and technological design for achieving durable anticorrosion protection.