15 April 2022 in Journal of Materials Research and Technology
20 September 2019 in Rapid Prototyping Journal
Purpose: This paper aims to present the design process, manufacturing and testing of a prototype of an axle carrier for Formula Student race car. The axle carrier is topologically optimized and additively manufactured using selective laser melting (SLM). Design/methodology/approach: The shape of the axle carrier was created in three design stages using topology optimization and four additional design stages based on finite element calculations and experimental testing. Topology optimization was performed on the basis of relevant load cases. The sixth design stage was manufactured by SLM and then tested on a loading device together with photogrammetry measurement to obtain the real deformation. Measured deformations were compared with deformation calculated by the finite element method (FEM), verified and experiences used in the last design stage. Findings: An additively manufactured axle carrier has a minimal safety factor of 1.2 according to experimental testing. The weight and maximal deformations are comparable with the milled part, although the material has about 50 per cent worse yield strength. The topologically optimized axle carrier proved big potential in the effective distribution of material and the improvement of toughness. Practical implications: This paper helps the Formula Student team to enhance the driving performance while keeping low weight. It also improves further development and upgrading of the race car. Originality/value: The whole design of the topologically optimized part was investigated – from estimation of the loads to experimental verification of FEM analysis on real part.
5 March 2025 in Advanced Engineering Materials
Lattice structures made of magnesium alloys are perspective for lightweight and biomedical applications. The processing of magnesium alloys and the production of complex geometries is possible with laser beam powder bed fusion. However, the small material volume of the lattice structures and the magnesium alloy require specific process parameters in order to achieve a high quality of the material. Therefore, the influence of two perspective laser strategies (contour strategy and hatch strategy), their combination, and skywriting is investigated. The geometry of the body‐centered‐cubic (BCC) lattice structure is used, representing the most difficult lattice structure to produce due to the struts inclination. A relative material density of over 99% is achieved with three laser strategies. The laser strategies have a direct influence on the pore distribution, pore shape, and microstructure. All these parameters can influence the mechanical performance of the BCC structures. The best performance is achieved with the hatch strategy with skywriting, which results in a low number of dangerous pores and a fine microstructure. The Young's modulus of material of 40 GPa and the effective elastic modulus of BCC structure of 136 MPa are achieved.
28 May 2024 in Advanced Engineering Materials
Multiscale topology optimization is a powerful tool for engineers seeking a design with minimum weight and maximum stiffness, using a structured material in the form of a lattice structure. Furthermore, the current trend is to combine multiple lattice topologies in one component to achieve the best possible response to local loading conditions while minimizing weight. Therefore, herein, a numerical and experimental evaluation by compression tests in two directions is performed for six basic lattice topologies and two hypotheses are tested. The first hypothesis states that an additional weight saving of more than 30% can be achieved by a better choice of lattice topology. The second hypothesis is based on the manufacturing limitations of the laser powder bed fusion technology and the assumption that a favorable loading direction parallel to the building direction exists. The first hypothesis is only confirmed for loading in the direction parallel to the building direction and the second only for two lattice topologies. When both hypotheses are combined, the additional weight reduction of the multiscale topology optimization result is 44.5% according to the numerical results and 32.7% according to the experimental verification.