1 January 2015 in Biomicrofluidics
Label-free isolation of single cells is essential for the growing field of single-cell analysis. Here, we present a device which prints single living cells encapsulated in free-flying picoliter droplets. It combines inkjet printing and impedance flow cytometry. Droplet volume can be controlled in the range of 500 pl–800 pl by piezo actuator displacement. Two sets of parallel facing electrodes in a 50 μm × 55 μm channel are applied to measure the presence and velocity of a single cell in real-time. Polystyrene beads with <5% variation in diameter generated signal variations of 12%–17% coefficients of variation. Single bead efficiency (i.e., printing events with single beads vs. total number of printing events) was 73% ± 11% at a throughput of approximately 9 events/min. Viability of printed HeLa cells and human primary fibroblasts was demonstrated by culturing cells for at least eight days.
23 April 2021 in Journal of Electronic Materials
GCGustavo Castillo-Hernandez
Gustavo Castillo-Hernandez
+5
Thermoelectric modules can be used in waste heat harvesting, sensing, and cooling applications. Here, we report on the fabrication and performance of a four-leg module based on abundant silicide materials. While previously optimized Mg2Si0.3Sn0.675Bi0.025 is used as the n-type leg, we employ a fractional factorial design based on the Taguchi methods mapping out a four-dimensional parameter space among Mnx-εMoεSi1.75−δGeδ higher manganese silicide compositions for the p-type material. The module is assembled using a scalable fabrication process, using a Cu metallization layer and a Pb-based soldering paste. The maximum power output density of 53 μW cm–2 is achieved at a hot-side temperature of 250 °C and a temperature difference of 100 °C. This low thermoelectric output is related to the high contact resistance between the thermoelectric materials and the metallic contacts, underlining the importance of improved metallization schemes for thermoelectric module assembly.
16 November 2017 in IEEE Transactions on Components, Packaging and Manufacturing Technology
A very compact and rugged 2.5-D integrated data logger has been built and tested. The data logger is capable of measuring accelerations exceeding 70,000 g. Microcontroller and flash memory as bare dies have been mounted onto a silicon interposer with through silicon vias using anisotropic conductive film and Au stud bump bonding. A microelectromechanical system accelerometer is mounted onto the interposer, using a robust customized flip-chip mounting approach. The interposer is mounted into a 16-pin leadless chip carrier package using isotropic conductive adhesive, where the conductive part is made of metallized polymer spheres. The ceramic package was mounted onto an application printed circuit board (PCB) with filters, power management, and an interface contact, using soldered plastic core solder balls (PCSBs). The diameter of the data logger is less than 9 mm, and the height is approximately 5 mm. The data logger fits within 12.7-mm (0.50 cal.) projectile, and acceleration measurements have been performed during firing, flight, and recovery. The measured accelerations have been verified by comparing the calculated projectile muzzle velocities with Doppler radar measurements.