21 February 2025 in Journal of the Energy Institute
30 January 2020 in Jurnal Inovasi dan Teknologi Material
Penambahan bahan semen tulang kedalam rongga tulang dapat menjadi salah satu alternatif untuk mencegah kerusakan tulang akibat osteoporosis. Kelemahan utama dari bahan implant ortopedik berbasis hydroksiapatit sinter adalah bahan dalam bentuk solid dimana dalam aplikasi pembedahan, sulit untuk mengisi rongga tulang dengan ukuran tertentu. Alternatif yang nyaman untuk bahan pengisi tulang suspensi adalah dengan menggunakan bahan Injectable bone substitute. Dalam studi ini dipelajari komposisi material Injectable Bone substitute dengan matrik berupa polimer CMC-gelatin dan HA/TCP sebagai filler. Dilakukan variasi rasio Hidroksiapatit (HA) / tri-calcium phosphate (TCP) (70:30; 50:50; 40:60)  untuk  mempelajari pengaruhnya terhadap sifat-sifat fisik dan mekanik campuran. Hasil uji FTIR menunjukkan gugus fungsi fosfat (PO43-) gugus fungsi karboksil dan gugus fungsi NH2 yang merujuk kepada bahan penyusunnya. Peningkatan porositas karena perubahan morfologi dikonfirmasi oleh gambar mikroskop polaritas. Hasil uji tekan menunjukkan berkurangnya  nilai kuat tekan dengan bertambahnya konsentrasi TCP dalam campuran. Semua kelompok uji menunjukkan kemiripan struktural dengan tulang cancellous dalam sifat porositas dan kekuatan mekanik.
30 April 2021 in International Journal of Advanced Research
This research focuses on the properties and capabilities of carbon nanotubes (CNTs) as reinforcing agents in ceramic composite bearing components. The addition of CNT to pure ceramics can form composites with much better performance than conventional ceramics for various applications. The study was started from the pure ceramics in their use as a component of bearing total hip arthroplasty and the damage that occurred after implantation. The study covers factors that cause degradation of conventional ceramics introduction of properties and use of CNTs as new reinforcing agents for ceramic composite materials widely used sintering method and the heat and pressure parameters used during the sintering process to meet the standards for the manufacture of Total Hip Arthroplasty (THA) bearing component. The contact and buckling behaviors of the CNTs influence the composites friction properties. The presence of CNT until 20 wt% of CNT exhibited improve wear resistance with lower friction with the increase of weight percent. CNT reinforced ceramic coating might be capable to withstand high load-bearing conditions. Plastic deformation can be one of the critical processes in wear in the ceramics wear mechanism. Other processes are cracking and chemical reaction. The microstructures and porosity take an important role in indicating the ceramics wear properties and wear mechanisms.